nfsd: move most of nfsfh.h to fs/nfsd

[safe/jmp/linux-2.6] / drivers / ide / alim15x3.c

diff --git a/drivers/ide/alim15x3.c b/drivers/ide/alim15x3.c
index d3513b6..e59b6de 100644 (file)
--- a/drivers/ide/alim15x3.c
+++ b/drivers/ide/alim15x3.c
@@ -189,19 +189,20 @@ static void ali_set_dma_mode(ide_drive_t *drive, const u8 speed)
 }
 
 /**
- *     ali15x3_dma_setup       -       begin a DMA phase
+ *     ali_dma_check   -       DMA check
  *     @drive: target device
+ *     @cmd: command
  *
  *     Returns 1 if the DMA cannot be performed, zero on success.
  */
 
-static int ali15x3_dma_setup(ide_drive_t *drive)
+static int ali_dma_check(ide_drive_t *drive, struct ide_cmd *cmd)
 {
        if (m5229_revision < 0xC2 && drive->media != ide_disk) {
-               if (rq_data_dir(drive->hwif->rq))
+               if (cmd->tf_flags & IDE_TFLAG_WRITE)
                        return 1;       /* try PIO instead of DMA */
        }
-       return ide_dma_setup(drive);
+       return 0;
 }
 
 /**
@@ -401,27 +402,23 @@ static u8 ali_cable_detect(ide_hwif_t *hwif)
        return cbl;
 }
 
-#if !defined(CONFIG_SPARC64) && !defined(CONFIG_PPC)
+#ifndef CONFIG_SPARC64
 /**
  *     init_hwif_ali15x3       -       Initialize the ALI IDE x86 stuff
  *     @hwif: interface to configure
  *
  *     Obtain the IRQ tables for an ALi based IDE solution on the PC
  *     class platforms. This part of the code isn't applicable to the
- *     Sparc and PowerPC systems.
+ *     Sparc systems.
  */
 
 static void __devinit init_hwif_ali15x3 (ide_hwif_t *hwif)
 {
-       struct pci_dev *dev = to_pci_dev(hwif->dev);
        u8 ideic, inmir;
        s8 irq_routing_table[] = { -1,  9, 3, 10, 4,  5, 7,  6,
                                      1, 11, 0, 12, 0, 14, 0, 15 };
        int irq = -1;
 
-       if (dev->device == PCI_DEVICE_ID_AL_M5229)
-               hwif->irq = hwif->channel ? 15 : 14;
-
        if (isa_dev) {
                /*
                 * read IDE interface control
@@ -454,7 +451,7 @@ static void __devinit init_hwif_ali15x3 (ide_hwif_t *hwif)
 }
 #else
 #define init_hwif_ali15x3 NULL
-#endif /* !defined(CONFIG_SPARC64) && !defined(CONFIG_PPC) */
+#endif /* CONFIG_SPARC64 */
 
 /**
  *     init_dma_ali15x3        -       set up DMA on ALi15x3
@@ -502,13 +499,13 @@ static const struct ide_port_ops ali_port_ops = {
 
 static const struct ide_dma_ops ali_dma_ops = {
        .dma_host_set           = ide_dma_host_set,
-       .dma_setup              = ali15x3_dma_setup,
-       .dma_exec_cmd           = ide_dma_exec_cmd,
+       .dma_setup              = ide_dma_setup,
        .dma_start              = ide_dma_start,
        .dma_end                = ide_dma_end,
        .dma_test_irq           = ide_dma_test_irq,
        .dma_lost_irq           = ide_dma_lost_irq,
-       .dma_timeout            = ide_dma_timeout,
+       .dma_check              = ali_dma_check,
+       .dma_timer_expiry       = ide_dma_sff_timer_expiry,
        .dma_sff_read_status    = ide_dma_sff_read_status,
 };