libata-sff: clean up inheritance in several drivers
[safe/jmp/linux-2.6] / drivers / ide / alim15x3.c
index 529f8e2..2c8016a 100644 (file)
@@ -61,6 +61,36 @@ static void ali_fifo_control(ide_hwif_t *hwif, ide_drive_t *drive, int on)
        pci_write_config_byte(pdev, pio_fifo, fifo);
 }
 
+static void ali_program_timings(ide_hwif_t *hwif, ide_drive_t *drive,
+                               struct ide_timing *t, u8 ultra)
+{
+       struct pci_dev *dev = to_pci_dev(hwif->dev);
+       int port = hwif->channel ? 0x5c : 0x58;
+       int udmat = 0x56 + hwif->channel;
+       u8 unit = drive->dn & 1, udma;
+       int shift = 4 * unit;
+
+       /* Set up the UDMA */
+       pci_read_config_byte(dev, udmat, &udma);
+       udma &= ~(0x0F << shift);
+       udma |= ultra << shift;
+       pci_write_config_byte(dev, udmat, udma);
+
+       if (t == NULL)
+               return;
+
+       t->setup = clamp_val(t->setup, 1, 8) & 7;
+       t->act8b = clamp_val(t->act8b, 1, 8) & 7;
+       t->rec8b = clamp_val(t->rec8b, 1, 16) & 15;
+       t->active = clamp_val(t->active, 1, 8) & 7;
+       t->recover = clamp_val(t->recover, 1, 16) & 15;
+
+       pci_write_config_byte(dev, port, t->setup);
+       pci_write_config_byte(dev, port + 1, (t->act8b << 4) | t->rec8b);
+       pci_write_config_byte(dev, port + unit + 2,
+                             (t->active << 4) | t->recover);
+}
+
 /**
  *     ali_set_pio_mode        -       set host controller for PIO mode
  *     @hwif: port
@@ -71,12 +101,9 @@ static void ali_fifo_control(ide_hwif_t *hwif, ide_drive_t *drive, int on)
 
 static void ali_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)
 {
-       struct pci_dev *dev = to_pci_dev(hwif->dev);
        ide_drive_t *pair = ide_get_pair_dev(drive);
        int bus_speed = ide_pci_clk ? ide_pci_clk : 33;
        unsigned long T =  1000000 / bus_speed; /* PCI clock based */
-       int port = hwif->channel ? 0x5c : 0x58;
-       u8 unit = drive->dn & 1;
        struct ide_timing t;
 
        ide_timing_compute(drive, drive->pio_mode, &t, T, 1);
@@ -93,21 +120,12 @@ static void ali_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)
                }
        }
 
-       t.setup = clamp_val(t.setup, 1, 8) & 7;
-       t.act8b = clamp_val(t.act8b, 1, 8) & 7;
-       t.rec8b = clamp_val(t.rec8b, 1, 16) & 15;
-       t.active = clamp_val(t.active, 1, 8) & 7;
-       t.recover = clamp_val(t.recover, 1, 16) & 15;
-
        /* 
         * PIO mode => ATA FIFO on, ATAPI FIFO off
         */
        ali_fifo_control(hwif, drive, (drive->media == ide_disk) ? 0x05 : 0x00);
 
-       pci_write_config_byte(dev, port, t.setup);
-       pci_write_config_byte(dev, port + 1, (t.act8b << 4) | t.rec8b);
-       pci_write_config_byte(dev, port + unit + 2,
-                             (t.active << 4) | t.recover);
+       ali_program_timings(hwif, drive, &t, 0);
 }
 
 /**
@@ -145,36 +163,34 @@ static u8 ali_udma_filter(ide_drive_t *drive)
 
 static void ali_set_dma_mode(ide_hwif_t *hwif, ide_drive_t *drive)
 {
+       static u8 udma_timing[7] = { 0xC, 0xB, 0xA, 0x9, 0x8, 0xF, 0xD };
        struct pci_dev *dev     = to_pci_dev(hwif->dev);
+       ide_drive_t *pair       = ide_get_pair_dev(drive);
+       int bus_speed           = ide_pci_clk ? ide_pci_clk : 33;
+       unsigned long T         =  1000000 / bus_speed; /* PCI clock based */
        const u8 speed          = drive->dma_mode;
-       u8 speed1               = speed;
-       u8 unit                 = drive->dn & 1;
        u8 tmpbyte              = 0x00;
-       int m5229_udma          = (hwif->channel) ? 0x57 : 0x56;
-
-       if (speed == XFER_UDMA_6)
-               speed1 = 0x47;
+       struct ide_timing t;
 
        if (speed < XFER_UDMA_0) {
-               u8 ultra_enable = (unit) ? 0x7f : 0xf7;
-               /*
-                * clear "ultra enable" bit
-                */
-               pci_read_config_byte(dev, m5229_udma, &tmpbyte);
-               tmpbyte &= ultra_enable;
-               pci_write_config_byte(dev, m5229_udma, tmpbyte);
+               ide_timing_compute(drive, drive->dma_mode, &t, T, 1);
+               if (pair) {
+                       struct ide_timing p;
 
-               /*
-                * FIXME: Oh, my... DMA timings are never set.
-                */
+                       ide_timing_compute(pair, pair->pio_mode, &p, T, 1);
+                       ide_timing_merge(&p, &t, &t,
+                               IDE_TIMING_SETUP | IDE_TIMING_8BIT);
+                       if (pair->dma_mode) {
+                               ide_timing_compute(pair, pair->dma_mode,
+                                               &p, T, 1);
+                               ide_timing_merge(&p, &t, &t,
+                                       IDE_TIMING_SETUP | IDE_TIMING_8BIT);
+                       }
+               }
+               ali_program_timings(hwif, drive, &t, 0);
        } else {
-               pci_read_config_byte(dev, m5229_udma, &tmpbyte);
-               tmpbyte &= (0x0f << ((1-unit) << 2));
-               /*
-                * enable ultra dma and set timing
-                */
-               tmpbyte |= ((0x08 | ((4-speed1)&0x07)) << (unit << 2));
-               pci_write_config_byte(dev, m5229_udma, tmpbyte);
+               ali_program_timings(hwif, drive, NULL,
+                               udma_timing[speed - XFER_UDMA_0]);
                if (speed >= XFER_UDMA_3) {
                        pci_read_config_byte(dev, 0x4b, &tmpbyte);
                        tmpbyte |= 1;