V4L/DVB: tm6000: README - add vbi

[safe/jmp/linux-2.6] / drivers / gpio / Kconfig

diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index f3549b8..fee678f 100644 (file)
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -70,6 +70,12 @@ config GPIO_MAX730X
 
 comment "Memory mapped GPIO expanders:"
 
+config GPIO_IT8761E
+       tristate "IT8761E GPIO support"
+       depends on GPIOLIB
+       help
+         Say yes here to support GPIO functionality of IT8761E super I/O chip.
+
 config GPIO_PL061
        bool "PrimeCell PL061 GPIO support"
        depends on ARM_AMBA
@@ -88,6 +94,23 @@ config GPIO_VR41XX
        help
          Say yes here to support the NEC VR4100 series General-purpose I/O Uint
 
+config GPIO_SCH
+       tristate "Intel SCH GPIO"
+       depends on GPIOLIB && PCI
+       select MFD_CORE
+       select LPC_SCH
+       help
+         Say yes here to support GPIO interface on Intel Poulsbo SCH.
+         The Intel SCH contains a total of 14 GPIO pins. Ten GPIOs are
+         powered by the core power rail and are turned off during sleep
+         modes (S3 and higher). The remaining four GPIOs are powered by
+         the Intel SCH suspend power supply. These GPIOs remain
+         active during S3. The suspend powered GPIOs can be used to wake the
+         system from the Suspend-to-RAM state.
+
+         This driver can also be built as a module. If so, the module
+         will be called sch-gpio.
+
 comment "I2C GPIO expanders:"
 
 config GPIO_MAX7300
@@ -134,6 +157,13 @@ config GPIO_PCA953X
          This driver can also be built as a module.  If so, the module
          will be called pca953x.
 
+config GPIO_PCA953X_IRQ
+       bool "Interrupt controller support for PCA953x"
+       depends on GPIO_PCA953X=y
+       help
+         Say yes here to enable the pca953x to be used as an interrupt
+         controller. It requires the driver to be built in the kernel.
+
 config GPIO_PCF857X
        tristate "PCF857x, PCA{85,96}7x, and MAX732[89] I2C GPIO expanders"
        depends on I2C
@@ -172,6 +202,20 @@ config GPIO_WM831X
          Say yes here to access the GPIO signals of WM831x power management
          chips from Wolfson Microelectronics.
 
+config GPIO_WM8350
+       tristate "WM8350 GPIOs"
+       depends on MFD_WM8350
+       help
+         Say yes here to access the GPIO signals of WM8350 power management
+         chips from Wolfson Microelectronics.
+
+config GPIO_WM8994
+       tristate "WM8994 GPIOs"
+       depends on MFD_WM8994
+       help
+         Say yes here to access the GPIO signals of WM8994 audio hub
+         CODECs from Wolfson Microelectronics.
+
 config GPIO_ADP5520
        tristate "GPIO Support for ADP5520 PMIC"
        depends on PMIC_ADP5520