#define CMD_TIMEOUT 0x000B
#define CMD_UNABORTABLE 0x000C
+/* Unit Attentions ASC's as defined for the MSA2012sa */
+#define POWER_OR_RESET 0x29
+#define STATE_CHANGED 0x2a
+#define UNIT_ATTENTION_CLEARED 0x2f
+#define LUN_FAILED 0x3e
+#define REPORT_LUNS_CHANGED 0x3f
+
+/* Unit Attentions ASCQ's as defined for the MSA2012sa */
+
+ /* These ASCQ's defined for ASC = POWER_OR_RESET */
+#define POWER_ON_RESET 0x00
+#define POWER_ON_REBOOT 0x01
+#define SCSI_BUS_RESET 0x02
+#define MSA_TARGET_RESET 0x03
+#define CONTROLLER_FAILOVER 0x04
+#define TRANSCEIVER_SE 0x05
+#define TRANSCEIVER_LVD 0x06
+
+ /* These ASCQ's defined for ASC = STATE_CHANGED */
+#define RESERVATION_PREEMPTED 0x03
+#define ASYM_ACCESS_CHANGED 0x06
+#define LUN_CAPACITY_CHANGED 0x09
+
//transfer direction
#define XFER_NONE 0x00
#define XFER_WRITE 0x01
#define I2O_INT_MASK 0x34
#define I2O_IBPOST_Q 0x40
#define I2O_OBPOST_Q 0x44
+#define I2O_DMA1_CFG 0x214
//Configuration Table
#define CFGTBL_ChangeReq 0x00000001l
//###########################################################################
//STRUCTURES
//###########################################################################
-#define CISS_MAX_LUN 16
+#define CISS_MAX_LUN 1024
#define CISS_MAX_PHYS_LUN 1024
// SCSI-3 Cmmands
BYTE block_size[4]; // Size of blocks in bytes
} ReadCapdata_struct;
-// 12 byte commands not implemented in firmware yet.
-// #define CCISS_READ 0xa8 // Read(12)
-// #define CCISS_WRITE 0xaa // Write(12)
- #define CCISS_READ 0x28 // Read(10)
- #define CCISS_WRITE 0x2a // Write(10)
+#define CCISS_READ_CAPACITY_16 0x9e /* Read Capacity 16 */
+
+/* service action to differentiate a 16 byte read capacity from
+ other commands that use the 0x9e SCSI op code */
+
+#define CCISS_READ_CAPACITY_16_SERVICE_ACT 0x10
+
+typedef struct _ReadCapdata_struct_16
+{
+ BYTE total_size[8]; /* Total size in blocks */
+ BYTE block_size[4]; /* Size of blocks in bytes */
+ BYTE prot_en:1; /* protection enable bit */
+ BYTE rto_en:1; /* reference tag own enable bit */
+ BYTE reserved:6; /* reserved bits */
+ BYTE reserved2[18]; /* reserved bytes per spec */
+} ReadCapdata_struct_16;
+
+/* Define the supported read/write commands for cciss based controllers */
+
+#define CCISS_READ_10 0x28 /* Read(10) */
+#define CCISS_WRITE_10 0x2a /* Write(10) */
+#define CCISS_READ_16 0x88 /* Read(16) */
+#define CCISS_WRITE_16 0x8a /* Write(16) */
+
+/* Define the CDB lengths supported by cciss based controllers */
+
+#define CDB_LEN10 10
+#define CDB_LEN16 16
// BMIC commands
#define BMIC_READ 0x26
LogDevAddr_struct LogDev;
} LUNAddr_struct;
+#define CTLR_LUNID "\0\0\0\0\0\0\0\0"
+
typedef struct _CommandListHeader_struct {
BYTE ReplyQueue;
BYTE SGList;
#define CMD_SCSI 0x03
#define CMD_MSG_DONE 0x04
#define CMD_MSG_TIMEOUT 0x05
+#define CMD_MSG_STALE 0xff
/* This structure needs to be divisible by 8 for new
* indexing method.
int ctlr;
int cmd_type;
long cmdindex;
- struct _CommandList_struct *prev;
- struct _CommandList_struct *next;
+ struct hlist_node list;
struct request * rq;
struct completion *waiting;
int retry_count;