NV_MMIO_BAR = 5,
NV_PORTS = 2,
- NV_PIO_MASK = 0x1f,
- NV_MWDMA_MASK = 0x07,
- NV_UDMA_MASK = 0x7f,
+ NV_PIO_MASK = ATA_PIO4,
+ NV_MWDMA_MASK = ATA_MWDMA2,
+ NV_UDMA_MASK = ATA_UDMA6,
NV_PORT0_SCR_REG_OFFSET = 0x00,
NV_PORT1_SCR_REG_OFFSET = 0x40,
static int nv_scr_read(struct ata_link *link, unsigned int sc_reg, u32 *val);
static int nv_scr_write(struct ata_link *link, unsigned int sc_reg, u32 val);
-static int nv_noclassify_hardreset(struct ata_link *link, unsigned int *class,
- unsigned long deadline);
+static int nv_hardreset(struct ata_link *link, unsigned int *class,
+ unsigned long deadline);
static void nv_nf2_freeze(struct ata_port *ap);
static void nv_nf2_thaw(struct ata_port *ap);
static void nv_ck804_freeze(struct ata_port *ap);
.slave_configure = nv_swncq_slave_config,
};
-static struct ata_port_operations nv_common_ops = {
+/*
+ * NV SATA controllers have various different problems with hardreset
+ * protocol depending on the specific controller and device.
+ *
+ * GENERIC:
+ *
+ * bko11195 reports that link doesn't come online after hardreset on
+ * generic nv's and there have been several other similar reports on
+ * linux-ide.
+ *
+ * bko12351#c23 reports that warmplug on MCP61 doesn't work with
+ * softreset.
+ *
+ * NF2/3:
+ *
+ * bko3352 reports nf2/3 controllers can't determine device signature
+ * reliably after hardreset. The following thread reports detection
+ * failure on cold boot with the standard debouncing timing.
+ *
+ * http://thread.gmane.org/gmane.linux.ide/34098
+ *
+ * bko12176 reports that hardreset fails to bring up the link during
+ * boot on nf2.
+ *
+ * CK804:
+ *
+ * For initial probing after boot and hot plugging, hardreset mostly
+ * works fine on CK804 but curiously, reprobing on the initial port
+ * by rescanning or rmmod/insmod fails to acquire the initial D2H Reg
+ * FIS in somewhat undeterministic way.
+ *
+ * SWNCQ:
+ *
+ * bko12351 reports that when SWNCQ is enabled, for hotplug to work,
+ * hardreset should be used and hardreset can't report proper
+ * signature, which suggests that mcp5x is closer to nf2 as long as
+ * reset quirkiness is concerned.
+ *
+ * bko12703 reports that boot probing fails for intel SSD with
+ * hardreset. Link fails to come online. Softreset works fine.
+ *
+ * The failures are varied but the following patterns seem true for
+ * all flavors.
+ *
+ * - Softreset during boot always works.
+ *
+ * - Hardreset during boot sometimes fails to bring up the link on
+ * certain comibnations and device signature acquisition is
+ * unreliable.
+ *
+ * - Hardreset is often necessary after hotplug.
+ *
+ * So, preferring softreset for boot probing and error handling (as
+ * hardreset might bring down the link) but using hardreset for
+ * post-boot probing should work around the above issues in most
+ * cases. Define nv_hardreset() which only kicks in for post-boot
+ * probing and use it for all variants.
+ */
+static struct ata_port_operations nv_generic_ops = {
.inherits = &ata_bmdma_port_ops,
+ .lost_interrupt = ATA_OP_NULL,
.scr_read = nv_scr_read,
.scr_write = nv_scr_write,
+ .hardreset = nv_hardreset,
};
-/* OSDL bz11195 reports that link doesn't come online after hardreset
- * on generic nv's and there have been several other similar reports
- * on linux-ide. Disable hardreset for generic nv's.
- */
-static struct ata_port_operations nv_generic_ops = {
- .inherits = &nv_common_ops,
- .hardreset = ATA_OP_NULL,
-};
-
-/* nf2 is ripe with hardreset related problems.
- *
- * kernel bz#3352 reports nf2/3 controllers can't determine device
- * signature reliably. The following thread reports detection failure
- * on cold boot with the standard debouncing timing.
- *
- * http://thread.gmane.org/gmane.linux.ide/34098
- *
- * And bz#12176 reports that hardreset simply doesn't work on nf2.
- * Give up on it and just don't do hardreset.
- */
static struct ata_port_operations nv_nf2_ops = {
.inherits = &nv_generic_ops,
.freeze = nv_nf2_freeze,
.thaw = nv_nf2_thaw,
};
-/* For initial probing after boot and hot plugging, hardreset mostly
- * works fine on CK804 but curiously, reprobing on the initial port by
- * rescanning or rmmod/insmod fails to acquire the initial D2H Reg FIS
- * in somewhat undeterministic way. Use noclassify hardreset.
- */
static struct ata_port_operations nv_ck804_ops = {
- .inherits = &nv_common_ops,
+ .inherits = &nv_generic_ops,
.freeze = nv_ck804_freeze,
.thaw = nv_ck804_thaw,
- .hardreset = nv_noclassify_hardreset,
.host_stop = nv_ck804_host_stop,
};
.host_stop = nv_adma_host_stop,
};
-/* Kernel bz#12351 reports that when SWNCQ is enabled, for hotplug to
- * work, hardreset should be used and hardreset can't report proper
- * signature, which suggests that mcp5x is closer to nf2 as long as
- * reset quirkiness is concerned. Define separate ops for mcp5x with
- * nv_noclassify_hardreset().
- */
-static struct ata_port_operations nv_mcp5x_ops = {
- .inherits = &nv_common_ops,
- .hardreset = nv_noclassify_hardreset,
-};
-
static struct ata_port_operations nv_swncq_ops = {
- .inherits = &nv_mcp5x_ops,
+ .inherits = &nv_generic_ops,
.qc_defer = ata_std_qc_defer,
.qc_prep = nv_swncq_qc_prep,
.pio_mask = NV_PIO_MASK,
.mwdma_mask = NV_MWDMA_MASK,
.udma_mask = NV_UDMA_MASK,
- .port_ops = &nv_mcp5x_ops,
+ .port_ops = &nv_generic_ops,
.private_data = NV_PI_PRIV(nv_generic_interrupt, &nv_sht),
},
/* SWNCQ */
static int adma_enabled;
static int swncq_enabled = 1;
+static int msi_enabled;
static void nv_adma_register_mode(struct ata_port *ap)
{
return 0;
}
-static int nv_noclassify_hardreset(struct ata_link *link, unsigned int *class,
- unsigned long deadline)
+static int nv_hardreset(struct ata_link *link, unsigned int *class,
+ unsigned long deadline)
{
- bool online;
- int rc;
+ struct ata_eh_context *ehc = &link->eh_context;
- rc = sata_link_hardreset(link, sata_deb_timing_hotplug, deadline,
- &online, NULL);
- return online ? -EAGAIN : rc;
+ /* Do hardreset iff it's post-boot probing, please read the
+ * comment above port ops for details.
+ */
+ if (!(link->ap->pflags & ATA_PFLAG_LOADING) &&
+ !ata_dev_enabled(link->device))
+ sata_link_hardreset(link, sata_deb_timing_hotplug, deadline,
+ NULL, NULL);
+ else {
+ const unsigned long *timing = sata_ehc_deb_timing(ehc);
+ int rc;
+
+ if (!(ehc->i.flags & ATA_EHI_QUIET))
+ ata_link_printk(link, KERN_INFO, "nv: skipping "
+ "hardreset on occupied port\n");
+
+ /* make sure the link is online */
+ rc = sata_link_resume(link, timing, deadline);
+ /* whine about phy resume failure but proceed */
+ if (rc && rc != -EOPNOTSUPP)
+ ata_link_printk(link, KERN_WARNING, "failed to resume "
+ "link (errno=%d)\n", rc);
+ }
+
+ /* device signature acquisition is unreliable */
+ return -EAGAIN;
}
static void nv_nf2_freeze(struct ata_port *ap)
ata_id_c_string(dev->id, model_num, ATA_ID_PROD, sizeof(model_num));
if (strncmp(model_num, "Maxtor", 6) == 0) {
- ata_scsi_change_queue_depth(sdev, 1);
+ ata_scsi_change_queue_depth(sdev, 1, SCSI_QDEPTH_DEFAULT);
ata_dev_printk(dev, KERN_NOTICE,
"Disabling SWNCQ mode (depth %x)\n", sdev->queue_depth);
}
} else if (type == SWNCQ)
nv_swncq_host_init(host);
+ if (msi_enabled) {
+ dev_printk(KERN_NOTICE, &pdev->dev, "Using MSI\n");
+ pci_enable_msi(pdev);
+ }
+
pci_set_master(pdev);
return ata_host_activate(host, pdev->irq, ipriv->irq_handler,
IRQF_SHARED, ipriv->sht);
module_init(nv_init);
module_exit(nv_exit);
module_param_named(adma, adma_enabled, bool, 0444);
-MODULE_PARM_DESC(adma, "Enable use of ADMA (Default: true)");
+MODULE_PARM_DESC(adma, "Enable use of ADMA (Default: false)");
module_param_named(swncq, swncq_enabled, bool, 0444);
MODULE_PARM_DESC(swncq, "Enable use of SWNCQ (Default: true)");
+module_param_named(msi, msi_enabled, bool, 0444);
+MODULE_PARM_DESC(msi, "Enable use of MSI (Default: false)");
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff