#include <linux/delay.h>
#include <scsi/scsi_host.h>
#include <linux/libata.h>
+#include <linux/dmi.h>
#define DRV_NAME "pata_via"
-#define DRV_VERSION "0.3.1"
+#define DRV_VERSION "0.3.3"
/*
* The following comes directly from Vojtech Pavlik's ide/pci/via82cxxx
VIA_BAD_ID = 0x100, /* Has wrong vendor ID (0x1107) */
VIA_BAD_AST = 0x200, /* Don't touch Address Setup Timing */
VIA_NO_ENABLES = 0x400, /* Has no enablebits */
+ VIA_SATA_PATA = 0x800, /* SATA/PATA combined configuration */
};
/*
u8 rev_max;
u16 flags;
} via_isa_bridges[] = {
+ { "vx800", PCI_DEVICE_ID_VIA_VX800, 0x00, 0x2f, VIA_UDMA_133 | VIA_BAD_AST },
{ "vt8237s", PCI_DEVICE_ID_VIA_8237S, 0x00, 0x2f, VIA_UDMA_133 | VIA_BAD_AST },
{ "vt8251", PCI_DEVICE_ID_VIA_8251, 0x00, 0x2f, VIA_UDMA_133 | VIA_BAD_AST },
- { "cx700", PCI_DEVICE_ID_VIA_CX700, 0x00, 0x2f, VIA_UDMA_133 | VIA_BAD_AST },
+ { "cx700", PCI_DEVICE_ID_VIA_CX700, 0x00, 0x2f, VIA_UDMA_133 | VIA_BAD_AST | VIA_SATA_PATA },
{ "vt6410", PCI_DEVICE_ID_VIA_6410, 0x00, 0x2f, VIA_UDMA_133 | VIA_BAD_AST | VIA_NO_ENABLES},
{ "vt8237a", PCI_DEVICE_ID_VIA_8237A, 0x00, 0x2f, VIA_UDMA_133 | VIA_BAD_AST },
{ "vt8237", PCI_DEVICE_ID_VIA_8237, 0x00, 0x2f, VIA_UDMA_133 | VIA_BAD_AST },
{ NULL }
};
+
+/*
+ * Cable special cases
+ */
+
+static const struct dmi_system_id cable_dmi_table[] = {
+ {
+ .ident = "Acer Ferrari 3400",
+ .matches = {
+ DMI_MATCH(DMI_BOARD_VENDOR, "Acer,Inc."),
+ DMI_MATCH(DMI_BOARD_NAME, "Ferrari 3400"),
+ },
+ },
+ { }
+};
+
+static int via_cable_override(struct pci_dev *pdev)
+{
+ /* Systems by DMI */
+ if (dmi_check_system(cable_dmi_table))
+ return 1;
+ /* Arima W730-K8/Targa Visionary 811/... */
+ if (pdev->subsystem_vendor == 0x161F && pdev->subsystem_device == 0x2032)
+ return 1;
+ return 0;
+}
+
+
/**
* via_cable_detect - cable detection
* @ap: ATA port
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
u32 ata66;
+ if (via_cable_override(pdev))
+ return ATA_CBL_PATA40_SHORT;
+
+ if ((config->flags & VIA_SATA_PATA) && ap->port_no == 0)
+ return ATA_CBL_SATA;
+
/* Early chips are 40 wire */
if ((config->flags & VIA_UDMA) < VIA_UDMA_66)
return ATA_CBL_PATA40;
/* UDMA 66 chips have only drive side logic */
- else if((config->flags & VIA_UDMA) < VIA_UDMA_100)
+ else if ((config->flags & VIA_UDMA) < VIA_UDMA_100)
return ATA_CBL_PATA_UNK;
/* UDMA 100 or later */
pci_read_config_dword(pdev, 0x50, &ata66);
two drives */
if (ata66 & (0x10100000 >> (16 * ap->port_no)))
return ATA_CBL_PATA80;
+ /* Check with ACPI so we can spot BIOS reported SATA bridges */
+ if (ata_acpi_init_gtm(ap) &&
+ ata_acpi_cbl_80wire(ap, ata_acpi_init_gtm(ap)))
+ return ATA_CBL_PATA80;
return ATA_CBL_PATA40;
}
-static int via_pre_reset(struct ata_port *ap, unsigned long deadline)
+static int via_pre_reset(struct ata_link *link, unsigned long deadline)
{
+ struct ata_port *ap = link->ap;
const struct via_isa_bridge *config = ap->host->private_data;
if (!(config->flags & VIA_NO_ENABLES)) {
return -ENOENT;
}
- return ata_std_prereset(ap, deadline);
+ return ata_std_prereset(link, deadline);
}
int ut;
int offset = 3 - (2*ap->port_no) - adev->devno;
-
/* Calculate the timing values we require */
ata_timing_compute(adev, mode, &t, T, UT);
ut = t.udma ? (0xe0 | (FIT(t.udma, 2, 9) - 2)) : 0x07;
break;
}
+
/* Set UDMA unless device is not UDMA capable */
- if (udma_type)
- pci_write_config_byte(pdev, 0x50 + offset, ut);
+ if (udma_type && t.udma) {
+ u8 cable80_status;
+
+ /* Get 80-wire cable detection bit */
+ pci_read_config_byte(pdev, 0x50 + offset, &cable80_status);
+ cable80_status &= 0x10;
+
+ pci_write_config_byte(pdev, 0x50 + offset, ut | cable80_status);
+ }
}
static void via_set_piomode(struct ata_port *ap, struct ata_device *adev)
};
static struct ata_port_operations via_port_ops = {
- .port_disable = ata_port_disable,
.set_piomode = via_set_piomode,
.set_dmamode = via_set_dmamode,
.mode_filter = ata_pci_default_filter,
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,
.irq_on = ata_irq_on,
- .irq_ack = ata_irq_ack,
- .port_start = ata_port_start,
+ .port_start = ata_sff_port_start,
};
static struct ata_port_operations via_port_ops_noirq = {
- .port_disable = ata_port_disable,
.set_piomode = via_set_piomode,
.set_dmamode = via_set_dmamode,
.mode_filter = ata_pci_default_filter,
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,
.irq_on = ata_irq_on,
- .irq_ack = ata_irq_ack,
- .port_start = ata_port_start,
+ .port_start = ata_sff_port_start,
};
/**
* @pdev: PCI device
* @flags: configuration flags
*
- * Set the FIFO properties for this device if neccessary. Used both on
+ * Set the FIFO properties for this device if necessary. Used both on
* set up and on and the resume path
*/
/* Early VIA without UDMA support */
static const struct ata_port_info via_mwdma_info = {
.sht = &via_sht,
- .flags = ATA_FLAG_SLAVE_POSS | ATA_FLAG_SETXFER_POLLING,
+ .flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
.port_ops = &via_port_ops
/* Ditto with IRQ masking required */
static const struct ata_port_info via_mwdma_info_borked = {
.sht = &via_sht,
- .flags = ATA_FLAG_SLAVE_POSS | ATA_FLAG_SETXFER_POLLING,
+ .flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
.port_ops = &via_port_ops_noirq,
/* VIA UDMA 33 devices (and borked 66) */
static const struct ata_port_info via_udma33_info = {
.sht = &via_sht,
- .flags = ATA_FLAG_SLAVE_POSS | ATA_FLAG_SETXFER_POLLING,
+ .flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
- .udma_mask = 0x7,
+ .udma_mask = ATA_UDMA2,
.port_ops = &via_port_ops
};
/* VIA UDMA 66 devices */
static const struct ata_port_info via_udma66_info = {
.sht = &via_sht,
- .flags = ATA_FLAG_SLAVE_POSS | ATA_FLAG_SETXFER_POLLING,
+ .flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
- .udma_mask = 0x1f,
+ .udma_mask = ATA_UDMA4,
.port_ops = &via_port_ops
};
/* VIA UDMA 100 devices */
static const struct ata_port_info via_udma100_info = {
.sht = &via_sht,
- .flags = ATA_FLAG_SLAVE_POSS | ATA_FLAG_SETXFER_POLLING,
+ .flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
- .udma_mask = 0x3f,
+ .udma_mask = ATA_UDMA5,
.port_ops = &via_port_ops
};
/* UDMA133 with bad AST (All current 133) */
static const struct ata_port_info via_udma133_info = {
.sht = &via_sht,
- .flags = ATA_FLAG_SLAVE_POSS | ATA_FLAG_SETXFER_POLLING,
+ .flags = ATA_FLAG_SLAVE_POSS,
.pio_mask = 0x1f,
.mwdma_mask = 0x07,
- .udma_mask = 0x7f, /* FIXME: should check north bridge */
+ .udma_mask = ATA_UDMA6, /* FIXME: should check north bridge */
.port_ops = &via_port_ops
};
struct ata_port_info type;
struct pci_dev *isa = NULL;
const struct via_isa_bridge *config;
static int printed_version;
- u8 t;
u8 enable;
u32 timing;
!!(config->flags & VIA_BAD_ID),
config->id, NULL))) {
- pci_read_config_byte(isa, PCI_REVISION_ID, &t);
- if (t >= config->rev_min &&
- t <= config->rev_max)
+ if (isa->revision >= config->rev_min &&
+ isa->revision <= config->rev_max)
break;
pci_dev_put(isa);
}
#endif
static const struct pci_device_id via[] = {
- { PCI_VDEVICE(VIA, PCI_DEVICE_ID_VIA_82C576_1), },
- { PCI_VDEVICE(VIA, PCI_DEVICE_ID_VIA_82C586_1), },
- { PCI_VDEVICE(VIA, PCI_DEVICE_ID_VIA_6410), },
- { PCI_VDEVICE(VIA, PCI_DEVICE_ID_VIA_SATA_EIDE), },
+ { PCI_VDEVICE(VIA, 0x0571), },
+ { PCI_VDEVICE(VIA, 0x0581), },
+ { PCI_VDEVICE(VIA, 0x1571), },
+ { PCI_VDEVICE(VIA, 0x3164), },
+ { PCI_VDEVICE(VIA, 0x5324), },
{ },
};
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff