#include <linux/libata.h>
#define DRV_NAME "pata_hpt37x"
-#define DRV_VERSION "0.6.12"
+#define DRV_VERSION "0.6.14"
struct hpt_clock {
u8 xfer_speed;
pci_read_config_byte(pdev, 0x5B, &scr2);
pci_write_config_byte(pdev, 0x5B, scr2 & ~0x01);
+
+ udelay(10); /* debounce */
+
/* Cable register now active */
pci_read_config_byte(pdev, 0x5A, &ata66);
/* Restore state */
pci_read_config_dword(pdev, addr1, ®);
mode = hpt37x_find_mode(ap, adev->pio_mode);
- mode &= ~0x8000000; /* No FIFO in PIO */
- mode &= ~0x30070000; /* Leave config bits alone */
- reg &= 0x30070000; /* Strip timing bits */
+ mode &= 0xCFC3FFFF; /* Leave DMA bits alone */
+ reg &= ~0xCFC3FFFF; /* Strip timing bits */
pci_write_config_dword(pdev, addr1, reg | mode);
}
{
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
u32 addr1, addr2;
- u32 reg;
- u32 mode;
+ u32 reg, mode, mask;
u8 fast;
addr1 = 0x40 + 4 * (adev->devno + 2 * ap->port_no);
fast |= 0x01;
pci_write_config_byte(pdev, addr2, fast);
+ mask = adev->dma_mode < XFER_UDMA_0 ? 0x31C001FF : 0x303C0000;
+
pci_read_config_dword(pdev, addr1, ®);
mode = hpt37x_find_mode(ap, adev->dma_mode);
- mode |= 0x8000000; /* FIFO in MWDMA or UDMA */
- mode &= ~0xC0000000; /* Leave config bits alone */
- reg &= 0xC0000000; /* Strip timing bits */
+ mode &= mask;
+ reg &= ~mask;
pci_write_config_dword(pdev, addr1, reg | mode);
}
mode = hpt37x_find_mode(ap, adev->pio_mode);
printk("Find mode for %d reports %X\n", adev->pio_mode, mode);
- mode &= ~0x80000000; /* No FIFO in PIO */
- mode &= ~0x30070000; /* Leave config bits alone */
- reg &= 0x30070000; /* Strip timing bits */
+ mode &= 0xCFC3FFFF; /* Leave DMA bits alone */
+ reg &= ~0xCFC3FFFF; /* Strip timing bits */
pci_write_config_dword(pdev, addr1, reg | mode);
}
{
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
u32 addr1, addr2;
- u32 reg;
- u32 mode;
+ u32 reg, mode, mask;
u8 fast;
addr1 = 0x40 + 4 * (adev->devno + 2 * ap->port_no);
fast &= ~0x07;
pci_write_config_byte(pdev, addr2, fast);
+ mask = adev->dma_mode < XFER_UDMA_0 ? 0x31C001FF : 0x303C0000;
+
pci_read_config_dword(pdev, addr1, ®);
mode = hpt37x_find_mode(ap, adev->dma_mode);
printk("Find mode for DMA %d reports %X\n", adev->dma_mode, mode);
- mode &= ~0xC0000000; /* Leave config bits alone */
- mode |= 0x80000000; /* FIFO in MWDMA or UDMA */
- reg &= 0xC0000000; /* Strip timing bits */
+ mode &= mask;
+ reg &= ~mask;
pci_write_config_dword(pdev, addr1, reg | mode);
}
static const int MHz[4] = { 33, 40, 50, 66 };
void *private_data = NULL;
const struct ata_port_info *ppi[] = { NULL, NULL };
-
+ u8 rev = dev->revision;
u8 irqmask;
- u32 class_rev;
u8 mcr1;
u32 freq;
int prefer_dpll = 1;
if (rc)
return rc;
- pci_read_config_dword(dev, PCI_CLASS_REVISION, &class_rev);
- class_rev &= 0xFF;
-
if (dev->device == PCI_DEVICE_ID_TTI_HPT366) {
/* May be a later chip in disguise. Check */
/* Older chips are in the HPT366 driver. Ignore them */
- if (class_rev < 3)
+ if (rev < 3)
return -ENODEV;
/* N series chips have their own driver. Ignore */
- if (class_rev == 6)
+ if (rev == 6)
return -ENODEV;
- switch(class_rev) {
+ switch(rev) {
case 3:
ppi[0] = &info_hpt370;
chip_table = &hpt370;
chip_table = &hpt372;
break;
default:
- printk(KERN_ERR "pata_hpt37x: Unknown HPT366 subtype please report (%d).\n", class_rev);
+ printk(KERN_ERR "pata_hpt37x: Unknown HPT366 "
+ "subtype, please report (%d).\n", rev);
return -ENODEV;
}
} else {
switch(dev->device) {
case PCI_DEVICE_ID_TTI_HPT372:
/* 372N if rev >= 2*/
- if (class_rev >= 2)
+ if (rev >= 2)
return -ENODEV;
ppi[0] = &info_hpt372;
chip_table = &hpt372a;
break;
case PCI_DEVICE_ID_TTI_HPT302:
/* 302N if rev > 1 */
- if (class_rev > 1)
+ if (rev > 1)
return -ENODEV;
ppi[0] = &info_hpt372;
/* Check this */
chip_table = &hpt302;
break;
case PCI_DEVICE_ID_TTI_HPT371:
- if (class_rev > 1)
+ if (rev > 1)
return -ENODEV;
ppi[0] = &info_hpt372;
chip_table = &hpt371;