/*
* pata_amd.c - AMD PATA for new ATA layer
* (C) 2005-2006 Red Hat Inc
- * Alan Cox <alan@redhat.com>
*
* Based on pata-sil680. Errata information is taken from data sheets
* and the amd74xx.c driver by Vojtech Pavlik. Nvidia SATA devices are
#include <linux/libata.h>
#define DRV_NAME "pata_amd"
-#define DRV_VERSION "0.3.10"
+#define DRV_VERSION "0.4.1"
/**
* timing_setup - shared timing computation and load
return ata_sff_prereset(link, deadline);
}
+/**
+ * amd_cable_detect - report cable type
+ * @ap: port
+ *
+ * AMD controller/BIOS setups record the cable type in word 0x42
+ */
+
static int amd_cable_detect(struct ata_port *ap)
{
static const u32 bitmask[2] = {0x03, 0x0C};
}
/**
+ * amd_fifo_setup - set the PIO FIFO for ATA/ATAPI
+ * @ap: ATA interface
+ * @adev: ATA device
+ *
+ * Set the PCI fifo for this device according to the devices present
+ * on the bus at this point in time. We need to turn the post write buffer
+ * off for ATAPI devices as we may need to issue a word sized write to the
+ * device as the final I/O
+ */
+
+static void amd_fifo_setup(struct ata_port *ap)
+{
+ struct ata_device *adev;
+ struct pci_dev *pdev = to_pci_dev(ap->host->dev);
+ static const u8 fifobit[2] = { 0xC0, 0x30};
+ u8 fifo = fifobit[ap->port_no];
+ u8 r;
+
+
+ ata_for_each_dev(adev, &ap->link, ENABLED) {
+ if (adev->class == ATA_DEV_ATAPI)
+ fifo = 0;
+ }
+ if (pdev->device == PCI_DEVICE_ID_AMD_VIPER_7411) /* FIFO is broken */
+ fifo = 0;
+
+ /* On the later chips the read prefetch bits become no-op bits */
+ pci_read_config_byte(pdev, 0x41, &r);
+ r &= ~fifobit[ap->port_no];
+ r |= fifo;
+ pci_write_config_byte(pdev, 0x41, r);
+}
+
+/**
* amd33_set_piomode - set initial PIO mode data
* @ap: ATA interface
* @adev: ATA device
static void amd33_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
+ amd_fifo_setup(ap);
timing_setup(ap, adev, 0x40, adev->pio_mode, 1);
}
static void amd66_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
+ amd_fifo_setup(ap);
timing_setup(ap, adev, 0x40, adev->pio_mode, 2);
}
static void amd100_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
+ amd_fifo_setup(ap);
timing_setup(ap, adev, 0x40, adev->pio_mode, 3);
}
static void amd133_set_piomode(struct ata_port *ap, struct ata_device *adev)
{
+ amd_fifo_setup(ap);
timing_setup(ap, adev, 0x40, adev->pio_mode, 4);
}
limit |= ATA_MASK_PIO;
if (!(limit & (ATA_MASK_MWDMA | ATA_MASK_UDMA)))
limit |= ATA_MASK_MWDMA | ATA_MASK_UDMA;
+ /* PIO4, MWDMA2, UDMA2 should always be supported regardless of
+ cable detection result */
+ limit |= ata_pack_xfermask(ATA_PIO4, ATA_MWDMA2, ATA_UDMA2);
ata_port_printk(ap, KERN_DEBUG, "nv_mode_filter: 0x%lx&0x%lx->0x%lx, "
"BIOS=0x%lx (0x%x) ACPI=0x%lx%s\n",
};
static const struct ata_port_operations amd_base_port_ops = {
- .inherits = &ata_bmdma_port_ops,
+ .inherits = &ata_bmdma32_port_ops,
.prereset = amd_pre_reset,
};
.set_dmamode = nv133_set_dmamode,
};
+static void amd_clear_fifo(struct pci_dev *pdev)
+{
+ u8 fifo;
+ /* Disable the FIFO, the FIFO logic will re-enable it as
+ appropriate */
+ pci_read_config_byte(pdev, 0x41, &fifo);
+ fifo &= 0x0F;
+ pci_write_config_byte(pdev, 0x41, fifo);
+}
+
static int amd_init_one(struct pci_dev *pdev, const struct pci_device_id *id)
{
static const struct ata_port_info info[10] = {
- { /* 0: AMD 7401 */
+ { /* 0: AMD 7401 - no swdma */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07, /* No SWDMA */
- .udma_mask = 0x07, /* UDMA 33 */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA2,
.port_ops = &amd33_port_ops
},
{ /* 1: Early AMD7409 - no swdma */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07,
- .udma_mask = ATA_UDMA4, /* UDMA 66 */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA4,
.port_ops = &amd66_port_ops
},
- { /* 2: AMD 7409, no swdma errata */
+ { /* 2: AMD 7409 */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07,
- .udma_mask = ATA_UDMA4, /* UDMA 66 */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA4,
.port_ops = &amd66_port_ops
},
{ /* 3: AMD 7411 */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07,
- .udma_mask = ATA_UDMA5, /* UDMA 100 */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA5,
.port_ops = &amd100_port_ops
},
{ /* 4: AMD 7441 */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07,
- .udma_mask = ATA_UDMA5, /* UDMA 100 */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA5,
.port_ops = &amd100_port_ops
},
- { /* 5: AMD 8111*/
+ { /* 5: AMD 8111 - no swdma */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07,
- .udma_mask = ATA_UDMA6, /* UDMA 133, no swdma */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA6,
.port_ops = &amd133_port_ops
},
- { /* 6: AMD 8111 UDMA 100 (Serenade) */
+ { /* 6: AMD 8111 UDMA 100 (Serenade) - no swdma */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07,
- .udma_mask = ATA_UDMA5, /* UDMA 100, no swdma */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA5,
.port_ops = &amd133_port_ops
},
{ /* 7: Nvidia Nforce */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07,
- .udma_mask = ATA_UDMA5, /* UDMA 100 */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA5,
.port_ops = &nv100_port_ops
},
- { /* 8: Nvidia Nforce2 and later */
+ { /* 8: Nvidia Nforce2 and later - no swdma */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07,
- .udma_mask = ATA_UDMA6, /* UDMA 133, no swdma */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA6,
.port_ops = &nv133_port_ops
},
{ /* 9: AMD CS5536 (Geode companion) */
.flags = ATA_FLAG_SLAVE_POSS,
- .pio_mask = 0x1f,
- .mwdma_mask = 0x07,
- .udma_mask = ATA_UDMA5, /* UDMA 100 */
+ .pio_mask = ATA_PIO4,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA5,
.port_ops = &amd100_port_ops
}
};
if (type < 3)
ata_pci_bmdma_clear_simplex(pdev);
-
- /* Check for AMD7411 */
- if (type == 3)
- /* FIFO is broken */
- pci_write_config_byte(pdev, 0x41, fifo & 0x0F);
- else
- pci_write_config_byte(pdev, 0x41, fifo | 0xF0);
-
+ if (pdev->vendor == PCI_VENDOR_ID_AMD)
+ amd_clear_fifo(pdev);
/* Cable detection on Nvidia chips doesn't work too well,
* cache BIOS programmed UDMA mode.
*/
return rc;
if (pdev->vendor == PCI_VENDOR_ID_AMD) {
- u8 fifo;
- pci_read_config_byte(pdev, 0x41, &fifo);
- if (pdev->device == PCI_DEVICE_ID_AMD_VIPER_7411)
- /* FIFO is broken */
- pci_write_config_byte(pdev, 0x41, fifo & 0x0F);
- else
- pci_write_config_byte(pdev, 0x41, fifo | 0xF0);
+ amd_clear_fifo(pdev);
if (pdev->device == PCI_DEVICE_ID_AMD_VIPER_7409 ||
pdev->device == PCI_DEVICE_ID_AMD_COBRA_7401)
ata_pci_bmdma_clear_simplex(pdev);
}
-
ata_host_resume(host);
return 0;
}
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff