* None.
*
* RETURNS:
- * Device type, %ATA_DEV_ATA, %ATA_DEV_ATAPI, or %ATA_DEV_UNKNOWN
- * the event of failure.
+ * Device type, %ATA_DEV_ATA, %ATA_DEV_ATAPI, %ATA_DEV_PMP or
+ * %ATA_DEV_UNKNOWN the event of failure.
*/
-
unsigned int ata_dev_classify(const struct ata_taskfile *tf)
{
/* Apple's open source Darwin code hints that some devices only
* put a proper signature into the LBA mid/high registers,
* So, we only check those. It's sufficient for uniqueness.
+ *
+ * ATA/ATAPI-7 (d1532v1r1: Feb. 19, 2003) specified separate
+ * signatures for ATA and ATAPI devices attached on SerialATA,
+ * 0x3c/0xc3 and 0x69/0x96 respectively. However, SerialATA
+ * spec has never mentioned about using different signatures
+ * for ATA/ATAPI devices. Then, Serial ATA II: Port
+ * Multiplier specification began to use 0x69/0x96 to identify
+ * port multpliers and 0x3c/0xc3 to identify SEMB device.
+ * ATA/ATAPI-7 dropped descriptions about 0x3c/0xc3 and
+ * 0x69/0x96 shortly and described them as reserved for
+ * SerialATA.
+ *
+ * We follow the current spec and consider that 0x69/0x96
+ * identifies a port multiplier and 0x3c/0xc3 a SEMB device.
*/
-
- if (((tf->lbam == 0) && (tf->lbah == 0)) ||
- ((tf->lbam == 0x3c) && (tf->lbah == 0xc3))) {
+ if ((tf->lbam == 0) && (tf->lbah == 0)) {
DPRINTK("found ATA device by sig\n");
return ATA_DEV_ATA;
}
- if (((tf->lbam == 0x14) && (tf->lbah == 0xeb)) ||
- ((tf->lbam == 0x69) && (tf->lbah == 0x96))) {
+ if ((tf->lbam == 0x14) && (tf->lbah == 0xeb)) {
DPRINTK("found ATAPI device by sig\n");
return ATA_DEV_ATAPI;
}
+ if ((tf->lbam == 0x69) && (tf->lbah == 0x96)) {
+ DPRINTK("found PMP device by sig\n");
+ return ATA_DEV_PMP;
+ }
+
+ if ((tf->lbam == 0x3c) && (tf->lbah == 0xc3)) {
+ printk("ata: SEMB device ignored\n");
+ return ATA_DEV_SEMB_UNSUP; /* not yet */
+ }
+
DPRINTK("unknown device\n");
return ATA_DEV_UNKNOWN;
}
(link->flags & ATA_LFLAG_HRST_TO_RESUME))
ehc->i.action |= ATA_EH_HARDRESET;
+ /* Some PMPs don't work with only SRST, force hardreset if PMP
+ * is supported.
+ */
+ if (ap->flags & ATA_FLAG_PMP)
+ ehc->i.action |= ATA_EH_HARDRESET;
+
/* if we're about to do hardreset, nothing more to do */
if (ehc->i.action & ATA_EH_HARDRESET)
return 0;
/* wait a while before checking status, see SRST for more info */
msleep(150);
+ /* If PMP is supported, we have to do follow-up SRST. Note
+ * that some PMPs don't send D2H Reg FIS after hardreset at
+ * all if the first port is empty. Wait for it just for a
+ * second and request follow-up SRST.
+ */
+ if (ap->flags & ATA_FLAG_PMP) {
+ ata_wait_ready(ap, jiffies + HZ);
+ return -EAGAIN;
+ }
+
rc = ata_wait_ready(ap, deadline);
/* link occupied, -ENODEV too is an error */
if (rc) {
* @val: Place to store read value
*
* Read SCR register @reg of @link into *@val. This function is
- * guaranteed to succeed if the cable type of the port is SATA
- * and the port implements ->scr_read.
+ * guaranteed to succeed if @link is ap->link, the cable type of
+ * the port is SATA and the port implements ->scr_read.
*
* LOCKING:
- * None.
+ * None if @link is ap->link. Kernel thread context otherwise.
*
* RETURNS:
* 0 on success, negative errno on failure.
*/
int sata_scr_read(struct ata_link *link, int reg, u32 *val)
{
- struct ata_port *ap = link->ap;
+ if (ata_is_host_link(link)) {
+ struct ata_port *ap = link->ap;
- if (sata_scr_valid(link))
- return ap->ops->scr_read(ap, reg, val);
- return -EOPNOTSUPP;
+ if (sata_scr_valid(link))
+ return ap->ops->scr_read(ap, reg, val);
+ return -EOPNOTSUPP;
+ }
+
+ return sata_pmp_scr_read(link, reg, val);
}
/**
* @val: value to write
*
* Write @val to SCR register @reg of @link. This function is
- * guaranteed to succeed if the cable type of the port is SATA
- * and the port implements ->scr_read.
+ * guaranteed to succeed if @link is ap->link, the cable type of
+ * the port is SATA and the port implements ->scr_read.
*
* LOCKING:
- * None.
+ * None if @link is ap->link. Kernel thread context otherwise.
*
* RETURNS:
* 0 on success, negative errno on failure.
*/
int sata_scr_write(struct ata_link *link, int reg, u32 val)
{
- struct ata_port *ap = link->ap;
+ if (ata_is_host_link(link)) {
+ struct ata_port *ap = link->ap;
- if (sata_scr_valid(link))
- return ap->ops->scr_write(ap, reg, val);
- return -EOPNOTSUPP;
+ if (sata_scr_valid(link))
+ return ap->ops->scr_write(ap, reg, val);
+ return -EOPNOTSUPP;
+ }
+
+ return sata_pmp_scr_write(link, reg, val);
}
/**
* function performs flush after writing to the register.
*
* LOCKING:
- * None.
+ * None if @link is ap->link. Kernel thread context otherwise.
*
* RETURNS:
* 0 on success, negative errno on failure.
*/
int sata_scr_write_flush(struct ata_link *link, int reg, u32 val)
{
- struct ata_port *ap = link->ap;
- int rc;
+ if (ata_is_host_link(link)) {
+ struct ata_port *ap = link->ap;
+ int rc;
- if (sata_scr_valid(link)) {
- rc = ap->ops->scr_write(ap, reg, val);
- if (rc == 0)
- rc = ap->ops->scr_read(ap, reg, &val);
- return rc;
+ if (sata_scr_valid(link)) {
+ rc = ap->ops->scr_write(ap, reg, val);
+ if (rc == 0)
+ rc = ap->ops->scr_read(ap, reg, &val);
+ return rc;
+ }
+ return -EOPNOTSUPP;
}
- return -EOPNOTSUPP;
+
+ return sata_pmp_scr_write(link, reg, val);
}
/**
if (ap->scsi_host)
scsi_host_put(ap->scsi_host);
+ kfree(ap->pmp_link);
kfree(ap);
host->ports[i] = NULL;
}
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff