bool
default y
+config LOCKDEP_SUPPORT
+ bool
+ default y
+
+config STACKTRACE_SUPPORT
+ bool
+ default y
+
config SEMAPHORE_SLEEPERS
bool
default y
config RWSEM_XCHGADD_ALGORITHM
bool
+config GENERIC_HWEIGHT
+ bool
+ default y
+
config GENERIC_CALIBRATE_DELAY
bool
default y
default "7" if GENERIC_CPU || MPSC
default "6" if MK8
+config X86_INTERNODE_CACHE_BYTES
+ int
+ default "4096" if X86_VSMP
+ default X86_L1_CACHE_BYTES if !X86_VSMP
+
config X86_TSC
bool
default y
cost of slightly increased overhead in some places. If unsure say
N here.
+config SCHED_MC
+ bool "Multi-core scheduler support"
+ depends on SMP
+ default y
+ help
+ Multi-core scheduler support improves the CPU scheduler's decision
+ making when dealing with multi-core CPU chips at a cost of slightly
+ increased overhead in some places. If unsure say N here.
+
source "kernel/Kconfig.preempt"
config NUMA
Northbridge of Opteron. It is recommended to use X86_64_ACPI_NUMA
instead, which also takes priority if both are compiled in.
+config NODES_SHIFT
+ int
+ default "6"
+ depends on NEED_MULTIPLE_NODES
+
# Dummy CONFIG option to select ACPI_NUMA from drivers/acpi/Kconfig.
config X86_64_ACPI_NUMA
bool "ACPI NUMA detection"
depends on NUMA
select ACPI
+ select PCI
select ACPI_NUMA
default y
help
def_bool y
depends on NUMA
+config OUT_OF_LINE_PFN_TO_PAGE
+ def_bool y
+ depends on DISCONTIGMEM
+
config NR_CPUS
int "Maximum number of CPUs (2-256)"
range 2 255
can be controlled through /sys/devices/system/cpu/cpu#.
Say N if you want to disable CPU hotplug.
+config ARCH_ENABLE_MEMORY_HOTPLUG
+ def_bool y
config HPET_TIMER
bool
bool "Provide RTC interrupt"
depends on HPET_TIMER && RTC=y
-config GART_IOMMU
- bool "K8 GART IOMMU support"
+# Mark as embedded because too many people got it wrong.
+# The code disables itself when not needed.
+config IOMMU
+ bool "IOMMU support" if EMBEDDED
default y
select SWIOTLB
+ select AGP
depends on PCI
help
- Support the IOMMU. Needed to run systems with more than 3GB of memory
- properly with 32-bit PCI devices that do not support DAC (Double Address
- Cycle). The IOMMU can be turned off at runtime with the iommu=off parameter.
- Normally the kernel will take the right choice by itself.
- This option includes a driver for the AMD Opteron/Athlon64 northbridge IOMMU
- and a software emulation used on other systems.
+ Support for full DMA access of devices with 32bit memory access only
+ on systems with more than 3GB. This is usually needed for USB,
+ sound, many IDE/SATA chipsets and some other devices.
+ Provides a driver for the AMD Athlon64/Opteron/Turion/Sempron GART
+ based IOMMU and a software bounce buffer based IOMMU used on Intel
+ systems and as fallback.
+ The code is only active when needed (enough memory and limited
+ device) unless CONFIG_IOMMU_DEBUG or iommu=force is specified
+ too.
+
+config CALGARY_IOMMU
+ bool "IBM Calgary IOMMU support"
+ default y
+ select SWIOTLB
+ depends on PCI && EXPERIMENTAL
+ help
+ Support for hardware IOMMUs in IBM's xSeries x366 and x460
+ systems. Needed to run systems with more than 3GB of memory
+ properly with 32-bit PCI devices that do not support DAC
+ (Double Address Cycle). Calgary also supports bus level
+ isolation, where all DMAs pass through the IOMMU. This
+ prevents them from going anywhere except their intended
+ destination. This catches hard-to-find kernel bugs and
+ mis-behaving drivers and devices that do not use the DMA-API
+ properly to set up their DMA buffers. The IOMMU can be
+ turned off at boot time with the iommu=off parameter.
+ Normally the kernel will make the right choice by itself.
If unsure, say Y.
-# need this always enabled with GART_IOMMU for the VIA workaround
+# need this always selected by IOMMU for the VIA workaround
config SWIOTLB
bool
- default y
- depends on GART_IOMMU
config X86_MCE
bool "Machine check support" if EMBEDDED
help
kexec is a system call that implements the ability to shutdown your
current kernel, and to start another kernel. It is like a reboot
- but it is indepedent of the system firmware. And like a reboot
+ but it is independent of the system firmware. And like a reboot
you can start any kernel with it, not just Linux.
- The name comes from the similiarity to the exec system call.
+ The name comes from the similarity to the exec system call.
It is an ongoing process to be certain the hardware in a machine
is properly shutdown, so do not be surprised if this code does not
optimal TLB usage. If you have pretty much any version of binutils,
this can increase your kernel build time by roughly one minute.
+config K8_NB
+ def_bool y
+ depends on AGP_AMD64 || IOMMU || (PCI && NUMA)
+
endmenu
#
bool "Support mmconfig PCI config space access"
depends on PCI && ACPI
-config UNORDERED_IO
- bool "Unordered IO mapping access"
- depends on EXPERIMENTAL
- help
- Use unordered stores to access IO memory mappings in device drivers.
- Still very experimental. When a driver works on IA64/ppc64/pa-risc it should
- work with this option, but it makes the drivers behave differently
- from i386. Requires that the driver writer used memory barriers
- properly.
-
source "drivers/pci/pcie/Kconfig"
source "drivers/pci/Kconfig"
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff