* Mikael Pettersson : PM converted to driver model.
*/
+#include <linux/perf_event.h>
#include <linux/kernel_stat.h>
#include <linux/mc146818rtc.h>
#include <linux/acpi_pmtmr.h>
#include <linux/smp.h>
#include <linux/mm.h>
+#include <asm/perf_event.h>
+#include <asm/x86_init.h>
#include <asm/pgalloc.h>
#include <asm/atomic.h>
#include <asm/mpspec.h>
#include <asm/mtrr.h>
#include <asm/smp.h>
#include <asm/mce.h>
+#include <asm/kvm_para.h>
unsigned int num_processors;
/*
* The highest APIC ID seen during enumeration.
- *
- * This determines the messaging protocol we can use: if all APIC IDs
- * are in the 0 ... 7 range, then we can use logical addressing which
- * has some performance advantages (better broadcasting).
- *
- * If there's an APIC ID above 8, we use physical addressing.
*/
unsigned int max_physical_apicid;
#ifdef CONFIG_X86_X2APIC
/* x2apic enabled before OS handover */
static int x2apic_preenabled;
-static int disable_x2apic;
static __init int setup_nox2apic(char *str)
{
if (x2apic_enabled()) {
return 0;
}
- disable_x2apic = 1;
setup_clear_cpu_cap(X86_FEATURE_X2APIC);
return 0;
}
}
/*
- * bare function to substitute write operation
- * and it's _that_ fast :)
- */
-static void native_apic_write_dummy(u32 reg, u32 v)
-{
- WARN_ON_ONCE((cpu_has_apic || !disable_apic));
-}
-
-static u32 native_apic_read_dummy(u32 reg)
-{
- WARN_ON_ONCE((cpu_has_apic || !disable_apic));
- return 0;
-}
-
-/*
- * right after this call apic->write/read doesn't do anything
- * note that there is no restore operation it works one way
+ * right after this call apic become NOOP driven
+ * so apic->write/read doesn't do anything
*/
void apic_disable(void)
{
- apic->read = native_apic_read_dummy;
- apic->write = native_apic_write_dummy;
+ pr_info("APIC: switched to apic NOOP\n");
+ apic = &apic_noop;
}
void native_apic_wait_icr_idle(void)
v = apic_read(APIC_LVTT);
v |= (APIC_LVT_MASKED | LOCAL_TIMER_VECTOR);
apic_write(APIC_LVTT, v);
- apic_write(APIC_TMICT, 0xffffffff);
+ apic_write(APIC_TMICT, 0);
break;
case CLOCK_EVT_MODE_RESUME:
/* Nothing to do here */
res = (((u64)(*deltatsc)) * pm_100ms);
do_div(res, deltapm);
apic_printk(APIC_VERBOSE, "TSC delta adjusted to "
- "PM-Timer: %lu (%ld) \n",
+ "PM-Timer: %lu (%ld)\n",
(unsigned long)res, *deltatsc);
*deltatsc = (long)res;
}
calibration_result = (delta * APIC_DIVISOR) / LAPIC_CAL_LOOPS;
apic_printk(APIC_VERBOSE, "..... delta %ld\n", delta);
- apic_printk(APIC_VERBOSE, "..... mult: %ld\n", lapic_clockevent.mult);
+ apic_printk(APIC_VERBOSE, "..... mult: %u\n", lapic_clockevent.mult);
apic_printk(APIC_VERBOSE, "..... calibration result: %u\n",
calibration_result);
{
unsigned long flags;
- if (!cpu_has_apic)
+ if (!cpu_has_apic && !apic_from_smp_config())
return;
local_irq_save(flags);
apic_write(APIC_ESR, 0);
}
#endif
+ perf_events_lapic_init();
preempt_disable();
* Double-check whether this APIC is really registered.
* This is meaningless in clustered apic mode, so we skip it.
*/
- if (!apic->apic_id_registered())
- BUG();
+ BUG_ON(!apic->apic_id_registered());
/*
* Intel recommends to set DFR, LDR and TPR before enabling
rdmsr(MSR_IA32_APICBASE, msr, msr2);
if (!(msr & X2APIC_ENABLE)) {
- pr_info("Enabling x2apic\n");
+ printk_once(KERN_INFO "Enabling x2apic\n");
wrmsr(MSR_IA32_APICBASE, msr | X2APIC_ENABLE, 0);
}
}
#endif /* CONFIG_X86_X2APIC */
-void __init enable_IR_x2apic(void)
+int __init enable_IR(void)
{
#ifdef CONFIG_INTR_REMAP
- int ret;
- unsigned long flags;
- struct IO_APIC_route_entry **ioapic_entries = NULL;
-
- ret = dmar_table_init();
- if (ret) {
- pr_debug("dmar_table_init() failed with %d:\n", ret);
- goto ir_failed;
- }
-
if (!intr_remapping_supported()) {
pr_debug("intr-remapping not supported\n");
- goto ir_failed;
+ return 0;
}
-
if (!x2apic_preenabled && skip_ioapic_setup) {
pr_info("Skipped enabling intr-remap because of skipping "
"io-apic setup\n");
- return;
+ return 0;
}
+ if (enable_intr_remapping(x2apic_supported()))
+ return 0;
+
+ pr_info("Enabled Interrupt-remapping\n");
+
+ return 1;
+
+#endif
+ return 0;
+}
+
+void __init enable_IR_x2apic(void)
+{
+ unsigned long flags;
+ struct IO_APIC_route_entry **ioapic_entries = NULL;
+ int ret, x2apic_enabled = 0;
+ int dmar_table_init_ret;
+
+ dmar_table_init_ret = dmar_table_init();
+ if (dmar_table_init_ret && !x2apic_supported())
+ return;
+
ioapic_entries = alloc_ioapic_entries();
if (!ioapic_entries) {
- pr_info("Allocate ioapic_entries failed: %d\n", ret);
- goto end;
+ pr_err("Allocate ioapic_entries failed\n");
+ goto out;
}
ret = save_IO_APIC_setup(ioapic_entries);
if (ret) {
pr_info("Saving IO-APIC state failed: %d\n", ret);
- goto end;
+ goto out;
}
local_irq_save(flags);
+ legacy_pic->mask_all();
mask_IO_APIC_setup(ioapic_entries);
- mask_8259A();
- ret = enable_intr_remapping(x2apic_supported());
- if (ret)
- goto end_restore;
+ if (dmar_table_init_ret)
+ ret = 0;
+ else
+ ret = enable_IR();
- pr_info("Enabled Interrupt-remapping\n");
+ if (!ret) {
+ /* IR is required if there is APIC ID > 255 even when running
+ * under KVM
+ */
+ if (max_physical_apicid > 255 || !kvm_para_available())
+ goto nox2apic;
+ /*
+ * without IR all CPUs can be addressed by IOAPIC/MSI
+ * only in physical mode
+ */
+ x2apic_force_phys();
+ }
+
+ x2apic_enabled = 1;
if (x2apic_supported() && !x2apic_mode) {
x2apic_mode = 1;
pr_info("Enabled x2apic\n");
}
-end_restore:
- if (ret)
- /*
- * IR enabling failed
- */
+nox2apic:
+ if (!ret) /* IR enabling failed */
restore_IO_APIC_setup(ioapic_entries);
-
- unmask_8259A();
+ legacy_pic->restore_mask();
local_irq_restore(flags);
-end:
+out:
if (ioapic_entries)
free_ioapic_entries(ioapic_entries);
- if (!ret)
+ if (x2apic_enabled)
return;
-ir_failed:
if (x2apic_preenabled)
- panic("x2apic enabled by bios. But IR enabling failed");
+ panic("x2apic: enabled by BIOS but kernel init failed.");
else if (cpu_has_x2apic)
- pr_info("Not enabling x2apic,Intr-remapping\n");
-#else
- if (!cpu_has_x2apic)
- return;
-
- if (x2apic_preenabled)
- panic("x2apic enabled prior OS handover,"
- " enable CONFIG_X86_X2APIC, CONFIG_INTR_REMAP");
-#endif
-
- return;
+ pr_info("Not enabling x2apic, Intr-remapping init failed.\n");
}
-
#ifdef CONFIG_X86_64
/*
* Detect and enable local APICs on non-SMP boards.
#ifdef CONFIG_X86_64
void __init early_init_lapic_mapping(void)
{
- unsigned long phys_addr;
-
/*
* If no local APIC can be found then go out
* : it means there is no mpatable and MADT
if (!smp_found_config)
return;
- phys_addr = mp_lapic_addr;
-
- set_fixmap_nocache(FIX_APIC_BASE, phys_addr);
+ set_fixmap_nocache(FIX_APIC_BASE, mp_lapic_addr);
apic_printk(APIC_VERBOSE, "mapped APIC to %16lx (%16lx)\n",
- APIC_BASE, phys_addr);
+ APIC_BASE, mp_lapic_addr);
/*
* Fetch the APIC ID of the BSP in case we have a
new_apicid = read_apic_id();
if (boot_cpu_physical_apicid != new_apicid) {
boot_cpu_physical_apicid = new_apicid;
+ /*
+ * yeah -- we lie about apic_version
+ * in case if apic was disabled via boot option
+ * but it's not a problem for SMP compiled kernel
+ * since smp_sanity_check is prepared for such a case
+ * and disable smp mode
+ */
apic_version[new_apicid] =
GET_APIC_VERSION(apic_read(APIC_LVR));
}
APIC_INTEGRATED(apic_version[boot_cpu_physical_apicid])) {
pr_err("BIOS bug, local APIC 0x%x not detected!...\n",
boot_cpu_physical_apicid);
- clear_cpu_cap(&boot_cpu_data, X86_FEATURE_APIC);
return -1;
}
#endif
enable_IR_x2apic();
-#ifdef CONFIG_X86_64
default_setup_apic_routing();
-#endif
verify_local_APIC();
connect_bsp_APIC();
localise_nmi_watchdog();
#endif
- setup_boot_clock();
+ x86_init.timers.setup_percpu_clockev();
#ifdef CONFIG_X86_64
check_nmi_watchdog();
#endif
if (apicid > max_physical_apicid)
max_physical_apicid = apicid;
-#ifdef CONFIG_X86_32
- /*
- * Would be preferable to switch to bigsmp when CONFIG_HOTPLUG_CPU=y
- * but we need to work other dependencies like SMP_SUSPEND etc
- * before this can be done without some confusion.
- * if (CPU_HOTPLUG_ENABLED || num_processors > 8)
- * - Ashok Raj <ashok.raj@intel.com>
- */
- if (max_physical_apicid >= 8) {
- switch (boot_cpu_data.x86_vendor) {
- case X86_VENDOR_INTEL:
- if (!APIC_XAPIC(version)) {
- def_to_bigsmp = 0;
- break;
- }
- /* If P4 and above fall through */
- case X86_VENDOR_AMD:
- def_to_bigsmp = 1;
- }
- }
-#endif
-
#if defined(CONFIG_SMP) || defined(CONFIG_X86_64)
early_per_cpu(x86_cpu_to_apicid, cpu) = apicid;
early_per_cpu(x86_bios_cpu_apicid, cpu) = apicid;
unsigned int l, h;
unsigned long flags;
int maxlvt;
- int ret;
+ int ret = 0;
struct IO_APIC_route_entry **ioapic_entries = NULL;
if (!apic_pm_state.active)
ioapic_entries = alloc_ioapic_entries();
if (!ioapic_entries) {
WARN(1, "Alloc ioapic_entries in lapic resume failed.");
- return -ENOMEM;
+ ret = -ENOMEM;
+ goto restore;
}
ret = save_IO_APIC_setup(ioapic_entries);
if (ret) {
WARN(1, "Saving IO-APIC state failed: %d\n", ret);
free_ioapic_entries(ioapic_entries);
- return ret;
+ goto restore;
}
mask_IO_APIC_setup(ioapic_entries);
- mask_8259A();
+ legacy_pic->mask_all();
}
if (x2apic_mode)
if (intr_remapping_enabled) {
reenable_intr_remapping(x2apic_mode);
- unmask_8259A();
+ legacy_pic->restore_mask();
restore_IO_APIC_setup(ioapic_entries);
free_ioapic_entries(ioapic_entries);
}
-
+restore:
local_irq_restore(flags);
- return 0;
+ return ret;
}
/*