#include <linux/device.h>
#include <linux/platform_device.h>
#include <linux/mfd/sh_mobile_sdhi.h>
+#include <linux/mmc/host.h>
+#include <linux/mmc/sh_mmcif.h>
#include <linux/mtd/physmap.h>
#include <linux/gpio.h>
#include <linux/interrupt.h>
#include <linux/mmc/host.h>
#include <linux/input.h>
#include <linux/input/sh_keysc.h>
-#include <linux/mfd/sh_mobile_sdhi.h>
#include <video/sh_mobile_lcdc.h>
#include <sound/sh_fsi.h>
#include <media/sh_mobile_ceu.h>
},
};
-struct sh_eth_plat_data sh_eth_plat = {
+static struct sh_eth_plat_data sh_eth_plat = {
.phy = 0x1f, /* SMSC LAN8700 */
.edmac_endian = EDMAC_LITTLE_ENDIAN,
.ether_link_active_low = 1
};
/* USB0 host */
-void usb0_port_power(int port, int power)
+static void usb0_port_power(int port, int power)
{
gpio_set_value(GPIO_PTB4, power);
}
};
/* USB1 host/function */
-void usb1_port_power(int port, int power)
+static void usb1_port_power(int port, int power)
{
gpio_set_value(GPIO_PTB5, power);
}
return 0;
}
-struct tsc2007_platform_data tsc2007_info = {
+static struct tsc2007_platform_data tsc2007_info = {
.model = 2007,
.x_plate_ohms = 180,
.get_pendown_state = ts_get_pendown_state,
};
#ifdef CONFIG_MFD_SH_MOBILE_SDHI
-/* SHDI0 */
+/* SDHI0 */
static void sdhi0_set_pwr(struct platform_device *pdev, int state)
{
gpio_set_value(GPIO_PTB6, state);
},
};
-/* SHDI1 */
+#if !defined(CONFIG_MMC_SH_MMCIF)
+/* SDHI1 */
static void sdhi1_set_pwr(struct platform_device *pdev, int state)
{
gpio_set_value(GPIO_PTB7, state);
.hwblk_id = HWBLK_SDHI1,
},
};
+#endif /* CONFIG_MMC_SH_MMCIF */
#else
.rate = 0, /* unknown */
};
-struct sh_fsi_platform_info fsi_info = {
+static struct sh_fsi_platform_info fsi_info = {
.portb_flags = SH_FSI_BRS_INV |
SH_FSI_OUT_SLAVE_MODE |
SH_FSI_IN_SLAVE_MODE |
#include <media/ak881x.h>
#include <media/sh_vou.h>
-struct ak881x_pdata ak881x_pdata = {
+static struct ak881x_pdata ak881x_pdata = {
.flags = AK881X_IF_MODE_SLAVE,
};
.platform_data = &ak881x_pdata,
};
-struct sh_vou_pdata sh_vou_pdata = {
+static struct sh_vou_pdata sh_vou_pdata = {
.bus_fmt = SH_VOU_BUS_8BIT,
.flags = SH_VOU_HSYNC_LOW | SH_VOU_VSYNC_LOW,
.board_info = &ak8813,
},
};
+#if defined(CONFIG_MMC_SH_MMCIF)
+/* SH_MMCIF */
+static void mmcif_set_pwr(struct platform_device *pdev, int state)
+{
+ gpio_set_value(GPIO_PTB7, state);
+}
+
+static void mmcif_down_pwr(struct platform_device *pdev)
+{
+ gpio_set_value(GPIO_PTB7, 0);
+}
+
+static struct resource sh_mmcif_resources[] = {
+ [0] = {
+ .name = "SH_MMCIF",
+ .start = 0xA4CA0000,
+ .end = 0xA4CA00FF,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ /* MMC2I */
+ .start = 29,
+ .flags = IORESOURCE_IRQ,
+ },
+ [2] = {
+ /* MMC3I */
+ .start = 30,
+ .flags = IORESOURCE_IRQ,
+ },
+};
+
+static struct sh_mmcif_plat_data sh_mmcif_plat = {
+ .set_pwr = mmcif_set_pwr,
+ .down_pwr = mmcif_down_pwr,
+ .sup_pclk = 0, /* SH7724: Max Pclk/2 */
+ .caps = MMC_CAP_4_BIT_DATA |
+ MMC_CAP_8_BIT_DATA |
+ MMC_CAP_NEEDS_POLL,
+ .ocr = MMC_VDD_32_33 | MMC_VDD_33_34,
+};
+
+static struct platform_device sh_mmcif_device = {
+ .name = "sh_mmcif",
+ .id = 0,
+ .dev = {
+ .platform_data = &sh_mmcif_plat,
+ },
+ .num_resources = ARRAY_SIZE(sh_mmcif_resources),
+ .resource = sh_mmcif_resources,
+};
+#endif
+
static struct platform_device *ecovec_devices[] __initdata = {
&heartbeat_device,
&nor_flash_device,
&keysc_device,
#ifdef CONFIG_MFD_SH_MOBILE_SDHI
&sdhi0_device,
+#if !defined(CONFIG_MMC_SH_MMCIF)
&sdhi1_device,
+#endif
#else
&msiof0_device,
#endif
&fsi_device,
&irda_device,
&vou_device,
+#if defined(CONFIG_MMC_SH_MMCIF)
+ &sh_mmcif_device,
+#endif
};
#ifdef CONFIG_I2C
gpio_request(GPIO_PTB6, NULL);
gpio_direction_output(GPIO_PTB6, 0);
+#if !defined(CONFIG_MMC_SH_MMCIF)
/* enable SDHI1 on CN12 (needs DS2.6,7 set to ON,OFF) */
gpio_request(GPIO_FN_SDHI1CD, NULL);
gpio_request(GPIO_FN_SDHI1WP, NULL);
/* I/O buffer drive ability is high for SDHI1 */
__raw_writew((__raw_readw(IODRIVEA) & ~0x3000) | 0x2000 , IODRIVEA);
+#endif /* CONFIG_MMC_SH_MMCIF */
#else
/* enable MSIOF0 on CN11 (needs DS2.4 set to OFF) */
gpio_request(GPIO_FN_MSIOF0_TXD, NULL);
gpio_request(GPIO_PTU5, NULL);
gpio_direction_output(GPIO_PTU5, 0);
+#if defined(CONFIG_MMC_SH_MMCIF)
+ /* enable MMCIF (needs DS2.6,7 set to OFF,ON) */
+ gpio_request(GPIO_FN_MMC_D7, NULL);
+ gpio_request(GPIO_FN_MMC_D6, NULL);
+ gpio_request(GPIO_FN_MMC_D5, NULL);
+ gpio_request(GPIO_FN_MMC_D4, NULL);
+ gpio_request(GPIO_FN_MMC_D3, NULL);
+ gpio_request(GPIO_FN_MMC_D2, NULL);
+ gpio_request(GPIO_FN_MMC_D1, NULL);
+ gpio_request(GPIO_FN_MMC_D0, NULL);
+ gpio_request(GPIO_FN_MMC_CLK, NULL);
+ gpio_request(GPIO_FN_MMC_CMD, NULL);
+ gpio_request(GPIO_PTB7, NULL);
+ gpio_direction_output(GPIO_PTB7, 0);
+
+ /* I/O buffer drive ability is high for MMCIF */
+ __raw_writew((__raw_readw(IODRIVEA) & ~0x3000) | 0x2000 , IODRIVEA);
+#endif
+
/* enable I2C device */
i2c_register_board_info(0, i2c0_devices,
ARRAY_SIZE(i2c0_devices));