National Semiconductor SCx200 support. */
-#include <linux/config.h>
#include <linux/module.h>
#include <linux/errno.h>
#include <linux/kernel.h>
#include <linux/init.h>
+#include <linux/mutex.h>
#include <linux/pci.h>
#include <linux/scx200.h>
.probe = scx200_probe,
};
-static DEFINE_SPINLOCK(scx200_gpio_config_lock);
+static DEFINE_MUTEX(scx200_gpio_config_lock);
-static int __devinit scx200_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
+static void __devinit scx200_init_shadow(void)
{
int bank;
+
+ /* read the current values driven on the GPIO signals */
+ for (bank = 0; bank < 2; ++bank)
+ scx200_gpio_shadow[bank] = inl(scx200_gpio_base + 0x10 * bank);
+}
+
+static int __devinit scx200_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
+{
unsigned base;
if (pdev->device == PCI_DEVICE_ID_NS_SCx200_BRIDGE ||
}
scx200_gpio_base = base;
-
- /* read the current values driven on the GPIO signals */
- for (bank = 0; bank < 2; ++bank)
- scx200_gpio_shadow[bank] = inl(scx200_gpio_base + 0x10 * bank);
+ scx200_init_shadow();
} else {
/* find the base of the Configuration Block */
u32 scx200_gpio_configure(unsigned index, u32 mask, u32 bits)
{
u32 config, new_config;
- unsigned long flags;
- spin_lock_irqsave(&scx200_gpio_config_lock, flags);
+ mutex_lock(&scx200_gpio_config_lock);
outl(index, scx200_gpio_base + 0x20);
config = inl(scx200_gpio_base + 0x24);
new_config = (config & mask) | bits;
outl(new_config, scx200_gpio_base + 0x24);
- spin_unlock_irqrestore(&scx200_gpio_config_lock, flags);
+ mutex_unlock(&scx200_gpio_config_lock);
return config;
}
-#if 0
-void scx200_gpio_dump(unsigned index)
-{
- u32 config = scx200_gpio_configure(index, ~0, 0);
-
- printk(KERN_INFO NAME ": GPIO-%02u: 0x%08lx %s %s %s %s %s %s %s\n",
- index, (unsigned long) config,
- (config & 1) ? "OE" : "TS", /* output enabled / tristate */
- (config & 2) ? "PP" : "OD", /* push pull / open drain */
- (config & 4) ? "PUE" : "PUD", /* pull up enabled/disabled */
- (config & 8) ? "LOCKED" : "", /* locked / unlocked */
- (config & 16) ? "LEVEL" : "EDGE", /* level/edge input */
- (config & 32) ? "HI" : "LO", /* trigger on rising/falling edge */
- (config & 64) ? "DEBOUNCE" : ""); /* debounce */
-}
-#endif /* 0 */
-
static int __init scx200_init(void)
{
printk(KERN_INFO NAME ": NatSemi SCx200 Driver\n");