#include <asm/reboot.h>
#include <asm/portmux.h>
#include <asm/dpmc.h>
+#ifdef CONFIG_REGULATOR_ADP_SWITCH
+#include <linux/regulator/adp_switch.h>
+#endif
#ifdef CONFIG_REGULATOR_AD5398
#include <linux/regulator/ad5398.h>
#endif
};
#endif
-#if defined(CONFIG_SND_BF5XX_SOC_AD1836) \
- || defined(CONFIG_SND_BF5XX_SOC_AD1836_MODULE)
+#if defined(CONFIG_SND_BF5XX_SOC_AD183X) \
+ || defined(CONFIG_SND_BF5XX_SOC_AD183X_MODULE)
static struct bfin5xx_spi_chip ad1836_spi_chip_info = {
.enable_dma = 0,
.bits_per_word = 16,
};
#endif
+#if defined(CONFIG_AD2S120X) || defined(CONFIG_AD2S120X_MODULE)
+unsigned short ad2s120x_platform_data[] = {
+ /* used as SAMPLE and RDVEL */
+ GPIO_PF5, GPIO_PF6, 0
+};
+
+static struct bfin5xx_spi_chip ad2s120x_spi_chip_info = {
+ .enable_dma = 0,
+ .bits_per_word = 16,
+};
+#endif
+
#if defined(CONFIG_MMC_SPI) || defined(CONFIG_MMC_SPI_MODULE)
#define MMC_SPI_CARD_DETECT_INT IRQ_PF5
},
#endif
-#if defined(CONFIG_SND_BF5XX_SOC_AD1836) \
- || defined(CONFIG_SND_BF5XX_SOC_AD1836_MODULE)
+#if defined(CONFIG_SND_BF5XX_SOC_AD183X) \
+ || defined(CONFIG_SND_BF5XX_SOC_AD183X_MODULE)
{
- .modalias = "ad1836",
+ .modalias = "ad183x",
.max_speed_hz = 3125000, /* max spi clock (SCK) speed in HZ */
.bus_num = 0,
.chip_select = 4,/* CONFIG_SND_BLACKFIN_SPI_PFBIT */
+ .platform_data = "ad1836", /* only includes chip name for the moment */
.controller_data = &ad1836_spi_chip_info,
.mode = SPI_MODE_3,
},
},
#endif
+#if defined(CONFIG_AD2S120X) || defined(CONFIG_AD2S120X_MODULE)
+ {
+ .modalias = "ad2s120x",
+ .bus_num = 0,
+ .chip_select = 4, /* CS, change it for your board */
+ .platform_data = ad2s120x_platform_data,
+ .controller_data = &ad2s120x_spi_chip_info,
+ },
+#endif
+
#if defined(CONFIG_MMC_SPI) || defined(CONFIG_MMC_SPI_MODULE)
{
.modalias = "mmc_spi",
};
#endif
+#if defined(CONFIG_BACKLIGHT_ADP8860) || defined(CONFIG_BACKLIGHT_ADP8860_MODULE)
+#include <linux/i2c/adp8860.h>
+static struct led_info adp8860_leds[] = {
+ {
+ .name = "adp8860-led7",
+ .default_trigger = "none",
+ .flags = ADP8860_LED_D7 | ADP8860_LED_OFFT_600ms,
+ },
+};
+
+static struct adp8860_backlight_platform_data adp8860_pdata = {
+ .bl_led_assign = ADP8860_BL_D1 | ADP8860_BL_D2 | ADP8860_BL_D3 |
+ ADP8860_BL_D4 | ADP8860_BL_D5 | ADP8860_BL_D6, /* 1 = Backlight 0 = Individual LED */
+
+ .bl_fade_in = ADP8860_FADE_T_1200ms, /* Backlight Fade-In Timer */
+ .bl_fade_out = ADP8860_FADE_T_1200ms, /* Backlight Fade-Out Timer */
+ .bl_fade_law = ADP8860_FADE_LAW_CUBIC1, /* fade-on/fade-off transfer characteristic */
+
+ .en_ambl_sens = 1, /* 1 = enable ambient light sensor */
+ .abml_filt = ADP8860_BL_AMBL_FILT_320ms, /* Light sensor filter time */
+
+ .l1_daylight_max = ADP8860_BL_CUR_mA(20), /* use BL_CUR_mA(I) 0 <= I <= 30 mA */
+ .l1_daylight_dim = ADP8860_BL_CUR_mA(0), /* typ = 0, use BL_CUR_mA(I) 0 <= I <= 30 mA */
+ .l2_office_max = ADP8860_BL_CUR_mA(6), /* use BL_CUR_mA(I) 0 <= I <= 30 mA */
+ .l2_office_dim = ADP8860_BL_CUR_mA(0), /* typ = 0, use BL_CUR_mA(I) 0 <= I <= 30 mA */
+ .l3_dark_max = ADP8860_BL_CUR_mA(2), /* use BL_CUR_mA(I) 0 <= I <= 30 mA */
+ .l3_dark_dim = ADP8860_BL_CUR_mA(0), /* typ = 0, use BL_CUR_mA(I) 0 <= I <= 30 mA */
+
+ .l2_trip = ADP8860_L2_COMP_CURR_uA(710), /* use L2_COMP_CURR_uA(I) 0 <= I <= 1106 uA */
+ .l2_hyst = ADP8860_L2_COMP_CURR_uA(73), /* use L2_COMP_CURR_uA(I) 0 <= I <= 1106 uA */
+ .l3_trip = ADP8860_L3_COMP_CURR_uA(43), /* use L3_COMP_CURR_uA(I) 0 <= I <= 138 uA */
+ .l3_hyst = ADP8860_L3_COMP_CURR_uA(11), /* use L3_COMP_CURR_uA(I) 0 <= I <= 138 uA */
+
+ .leds = adp8860_leds,
+ .num_leds = ARRAY_SIZE(adp8860_leds),
+ .led_fade_law = ADP8860_FADE_LAW_SQUARE, /* fade-on/fade-off transfer characteristic */
+ .led_fade_in = ADP8860_FADE_T_600ms,
+ .led_fade_out = ADP8860_FADE_T_600ms,
+ .led_on_time = ADP8860_LED_ONT_200ms,
+};
+#endif
+
#if defined(CONFIG_REGULATOR_AD5398) || defined(CONFIG_REGULATOR_AD5398_MODULE)
static struct regulator_consumer_supply ad5398_consumer = {
.supply = "current",
},
#endif
+#if defined(CONFIG_AD7414) || defined(CONFIG_AD7414_MODULE)
+ {
+ I2C_BOARD_INFO("ad7414", 0x9),
+ .irq = IRQ_PG5,
+ /*
+ * platform_data pointer is borrwoed by the driver to
+ * store custimer defined IRQ ALART level mode.
+ * only IRQF_TRIGGER_HIGH and IRQF_TRIGGER_LOW are valid.
+ */
+ .platform_data = (void *)IRQF_TRIGGER_LOW,
+ },
+#endif
+
+#if defined(CONFIG_AD7416) || defined(CONFIG_AD7416_MODULE)
+ {
+ I2C_BOARD_INFO("ad7417", 0xb),
+ .irq = IRQ_PG5,
+ /*
+ * platform_data pointer is borrwoed by the driver to
+ * store custimer defined IRQ ALART level mode.
+ * only IRQF_TRIGGER_HIGH and IRQF_TRIGGER_LOW are valid.
+ */
+ .platform_data = (void *)IRQF_TRIGGER_LOW,
+ },
+#endif
+
#if defined(CONFIG_BFIN_TWI_LCD) || defined(CONFIG_BFIN_TWI_LCD_MODULE)
{
I2C_BOARD_INFO("pcf8574_lcd", 0x22),
I2C_BOARD_INFO("adau1761", 0x38),
},
#endif
+#if defined(CONFIG_SND_SOC_ADAU1361) || defined(CONFIG_SND_SOC_ADAU1361_MODULE)
+ {
+ I2C_BOARD_INFO("adau1361", 0x38),
+ },
+#endif
#if defined(CONFIG_AD525X_DPOT) || defined(CONFIG_AD525X_DPOT_MODULE)
{
I2C_BOARD_INFO("ad5258", 0x18),
.platform_data = (void *)&ad5398_i2c_platform_data,
},
#endif
+#if defined(CONFIG_BACKLIGHT_ADP8860) || defined(CONFIG_BACKLIGHT_ADP8860_MODULE)
+ {
+ I2C_BOARD_INFO("adp8860", 0x2A),
+ .platform_data = (void *)&adp8860_pdata,
+ },
+#endif
};
#if defined(CONFIG_SERIAL_BFIN_SPORT) || defined(CONFIG_SERIAL_BFIN_SPORT_MODULE)
};
#endif
+#if defined(CONFIG_REGULATOR_ADP_SWITCH) || defined(CONFIG_REGULATOR_ADP_SWITCH_MODULE)
+#define REGULATOR_ADP122 "adp122"
+#define REGULATOR_ADP150 "adp150"
+
+static struct regulator_consumer_supply adp122_consumers = {
+ .supply = REGULATOR_ADP122,
+};
+
+static struct regulator_consumer_supply adp150_consumers = {
+ .supply = REGULATOR_ADP150,
+};
+
+static struct regulator_init_data adp_switch_regulator_data[] = {
+ {
+ .constraints = {
+ .name = REGULATOR_ADP122,
+ .valid_ops_mask = REGULATOR_CHANGE_STATUS,
+ .min_uA = 0,
+ .max_uA = 300000,
+ },
+ .num_consumer_supplies = 1, /* only 1 */
+ .consumer_supplies = &adp122_consumers,
+ .driver_data = (void *)GPIO_PF2, /* gpio port only */
+ },
+ {
+ .constraints = {
+ .name = REGULATOR_ADP150,
+ .valid_ops_mask = REGULATOR_CHANGE_STATUS,
+ .min_uA = 0,
+ .max_uA = 150000,
+ },
+ .num_consumer_supplies = 1, /* only 1 */
+ .consumer_supplies = &adp150_consumers,
+ .driver_data = (void *)GPIO_PF3, /* gpio port only */
+ },
+};
+
+static struct adp_switch_platform_data adp_switch_pdata = {
+ .regulator_num = ARRAY_SIZE(adp_switch_regulator_data),
+ .regulator_data = adp_switch_regulator_data,
+};
+
+static struct platform_device adp_switch_device = {
+ .name = "adp_switch",
+ .id = 0,
+ .dev = {
+ .platform_data = &adp_switch_pdata,
+ },
+};
+
+#if defined(CONFIG_REGULATOR_USERSPACE_CONSUMER) || \
+ defined(CONFIG_REGULATOR_USERSPACE_CONSUMER_MODULE)
+static struct regulator_bulk_data adp122_bulk_data = {
+ .supply = REGULATOR_ADP122,
+};
+
+static struct regulator_userspace_consumer_data adp122_userspace_comsumer_data = {
+ .name = REGULATOR_ADP122,
+ .num_supplies = 1,
+ .supplies = &adp122_bulk_data,
+};
+
+static struct platform_device adp122_userspace_consumer_device = {
+ .name = "reg-userspace-consumer",
+ .id = 0,
+ .dev = {
+ .platform_data = &adp122_userspace_comsumer_data,
+ },
+};
+
+static struct regulator_bulk_data adp150_bulk_data = {
+ .supply = REGULATOR_ADP150,
+};
+
+static struct regulator_userspace_consumer_data adp150_userspace_comsumer_data = {
+ .name = REGULATOR_ADP150,
+ .num_supplies = 1,
+ .supplies = &adp150_bulk_data,
+};
+
+static struct platform_device adp150_userspace_consumer_device = {
+ .name = "reg-userspace-consumer",
+ .id = 1,
+ .dev = {
+ .platform_data = &adp150_userspace_comsumer_data,
+ },
+};
+#endif
+#endif
+
+
static struct platform_device *stamp_devices[] __initdata = {
&bfin_dpmc,
&ad5398_userspace_consumer_device,
#endif
#endif
+
+#if defined(CONFIG_REGULATOR_ADP_SWITCH) || defined(CONFIG_REGULATOR_ADP_SWITCH_MODULE)
+ &adp_switch_device,
+#if defined(CONFIG_REGULATOR_USERSPACE_CONSUMER) || \
+ defined(CONFIG_REGULATOR_USERSPACE_CONSUMER_MODULE)
+ &adp122_userspace_consumer_device,
+ &adp150_userspace_consumer_device,
+#endif
+#endif
};
static int __init stamp_init(void)
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff