omap: mux: Replace omap_cfg_reg() with new style signal or gpio functions

[safe/jmp/linux-2.6] / arch / arm / mach-omap2 / board-omap3evm.c

diff --git a/arch/arm/mach-omap2/board-omap3evm.c b/arch/arm/mach-omap2/board-omap3evm.c
index ad174ae..0457f61 100644 (file)
--- a/arch/arm/mach-omap2/board-omap3evm.c
+++ b/arch/arm/mach-omap2/board-omap3evm.c
@@ -224,7 +224,7 @@ static int omap3evm_twl_gpio_setup(struct device *dev,
                unsigned gpio, unsigned ngpio)
 {
        /* gpio + 0 is "mmc0_cd" (input/IRQ) */
-       omap_cfg_reg(L8_34XX_GPIO63);
+       omap_mux_init_gpio(63, OMAP_PIN_INPUT);
        mmc[0].gpio_cd = gpio + 0;
        twl4030_mmc_init(mmc);
 
@@ -450,24 +450,24 @@ static void __init omap3_evm_init(void)
 #endif
        if (get_omap3_evm_rev() >= OMAP3EVM_BOARD_GEN_2) {
                /* enable EHCI VBUS using GPIO22 */
-               omap_cfg_reg(AF9_34XX_GPIO22);
+               omap_mux_init_gpio(22, OMAP_PIN_INPUT_PULLUP);
                gpio_request(OMAP3_EVM_EHCI_VBUS, "enable EHCI VBUS");
                gpio_direction_output(OMAP3_EVM_EHCI_VBUS, 0);
                gpio_set_value(OMAP3_EVM_EHCI_VBUS, 1);
 
                /* Select EHCI port on main board */
-               omap_cfg_reg(U3_34XX_GPIO61);
+               omap_mux_init_gpio(61, OMAP_PIN_INPUT_PULLUP);
                gpio_request(OMAP3_EVM_EHCI_SELECT, "select EHCI port");
                gpio_direction_output(OMAP3_EVM_EHCI_SELECT, 0);
                gpio_set_value(OMAP3_EVM_EHCI_SELECT, 0);
 
                /* setup EHCI phy reset config */
-               omap_cfg_reg(AH14_34XX_GPIO21);
+               omap_mux_init_gpio(21, OMAP_PIN_INPUT_PULLUP);
                ehci_pdata.reset_gpio_port[1] = 21;
 
        } else {
                /* setup EHCI phy reset on MDC */
-               omap_cfg_reg(AF4_34XX_GPIO135_OUT);
+               omap_mux_init_gpio(135, OMAP_PIN_OUTPUT);
                ehci_pdata.reset_gpio_port[1] = 135;
        }
        usb_musb_init();