*/
#include <linux/delay.h>
-#include <linux/device.h>
+#include <linux/platform_device.h>
#include <linux/interrupt.h>
+#include <linux/irq.h>
#include <linux/init.h>
#include <linux/kernel.h>
+#include <linux/mtd/physmap.h>
#include <linux/notifier.h>
#include <linux/reboot.h>
#include <linux/serial_8250.h>
#include <linux/serial_reg.h>
+#include <linux/smc91x.h>
-#include <asm/hardware.h>
+#include <mach/hardware.h>
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
-#include <asm/mach/flash.h>
#include <asm/mach/map.h>
-#include <asm/arch/common.h>
-#include <asm/arch/gpio.h>
-#include <asm/arch/mux.h>
-#include <asm/arch/tc.h>
-#include <asm/arch/usb.h>
-
-extern void omap_init_time(void);
-extern int omap_gpio_init(void);
+#include <plat/common.h>
+#include <mach/gpio.h>
+#include <plat/flash.h>
+#include <plat/mux.h>
+#include <plat/tc.h>
+#include <plat/usb.h>
static struct plat_serial8250_port voiceblue_ports[] = {
{
static struct platform_device serial_device = {
.name = "serial8250",
- .id = 1,
+ .id = PLAT8250_DEV_PLATFORM1,
.dev = {
.platform_data = voiceblue_ports,
},
}
arch_initcall(ext_uart_init);
-static struct flash_platform_data voiceblue_flash_data = {
- .map_name = "cfi_probe",
+static struct physmap_flash_data voiceblue_flash_data = {
.width = 2,
+ .set_vpp = omap1_set_vpp,
};
static struct resource voiceblue_flash_resource = {
};
static struct platform_device voiceblue_flash_device = {
- .name = "omapflash",
+ .name = "physmap-flash",
.id = 0,
.dev = {
.platform_data = &voiceblue_flash_data,
.resource = &voiceblue_flash_resource,
};
+static struct smc91x_platdata voiceblue_smc91x_info = {
+ .flags = SMC91X_USE_16BIT | SMC91X_NOWAIT,
+ .leda = RPC_LED_100_10,
+ .ledb = RPC_LED_TX_RX,
+};
+
static struct resource voiceblue_smc91x_resources[] = {
[0] = {
.start = OMAP_CS2_PHYS + 0x300,
[1] = {
.start = OMAP_GPIO_IRQ(8),
.end = OMAP_GPIO_IRQ(8),
- .flags = IORESOURCE_IRQ,
+ .flags = IORESOURCE_IRQ | IORESOURCE_IRQ_HIGHEDGE,
},
};
static struct platform_device voiceblue_smc91x_device = {
.name = "smc91x",
.id = 0,
+ .dev = {
+ .platform_data = &voiceblue_smc91x_info,
+ },
.num_resources = ARRAY_SIZE(voiceblue_smc91x_resources),
.resource = voiceblue_smc91x_resources,
};
.pins[2] = 6,
};
-static struct omap_mmc_config voiceblue_mmc_config __initdata = {
- .mmc[0] = {
- .enabled = 1,
- .power_pin = 2,
- .switch_pin = -1,
- },
-};
-
static struct omap_board_config_kernel voiceblue_config[] = {
- { OMAP_TAG_USB, &voiceblue_usb_config },
- { OMAP_TAG_MMC, &voiceblue_mmc_config },
};
static void __init voiceblue_init_irq(void)
{
+ omap1_init_common_hw();
omap_init_irq();
omap_gpio_init();
}
static void __init voiceblue_init(void)
{
+ /* mux pins for uarts */
+ omap_cfg_reg(UART1_TX);
+ omap_cfg_reg(UART1_RTS);
+ omap_cfg_reg(UART2_TX);
+ omap_cfg_reg(UART2_RTS);
+ omap_cfg_reg(UART3_TX);
+ omap_cfg_reg(UART3_RX);
+
/* Watchdog */
- omap_request_gpio(0);
+ gpio_request(0, "Watchdog");
/* smc91x reset */
- omap_request_gpio(7);
- omap_set_gpio_direction(7, 0);
- omap_set_gpio_dataout(7, 1);
+ gpio_request(7, "SMC91x reset");
+ gpio_direction_output(7, 1);
udelay(2); /* wait at least 100ns */
- omap_set_gpio_dataout(7, 0);
+ gpio_set_value(7, 0);
mdelay(50); /* 50ms until PHY ready */
/* smc91x interrupt pin */
- omap_request_gpio(8);
+ gpio_request(8, "SMC91x irq");
/* 16C554 reset*/
- omap_request_gpio(6);
- omap_set_gpio_direction(6, 0);
- omap_set_gpio_dataout(6, 0);
+ gpio_request(6, "16C554 reset");
+ gpio_direction_output(6, 0);
/* 16C554 interrupt pins */
- omap_request_gpio(12);
- omap_request_gpio(13);
- omap_request_gpio(14);
- omap_request_gpio(15);
- set_irq_type(OMAP_GPIO_IRQ(12), IRQT_RISING);
- set_irq_type(OMAP_GPIO_IRQ(13), IRQT_RISING);
- set_irq_type(OMAP_GPIO_IRQ(14), IRQT_RISING);
- set_irq_type(OMAP_GPIO_IRQ(15), IRQT_RISING);
+ gpio_request(12, "16C554 irq");
+ gpio_request(13, "16C554 irq");
+ gpio_request(14, "16C554 irq");
+ gpio_request(15, "16C554 irq");
+ set_irq_type(gpio_to_irq(12), IRQ_TYPE_EDGE_RISING);
+ set_irq_type(gpio_to_irq(13), IRQ_TYPE_EDGE_RISING);
+ set_irq_type(gpio_to_irq(14), IRQ_TYPE_EDGE_RISING);
+ set_irq_type(gpio_to_irq(15), IRQ_TYPE_EDGE_RISING);
platform_add_devices(voiceblue_devices, ARRAY_SIZE(voiceblue_devices));
omap_board_config = voiceblue_config;
omap_board_config_size = ARRAY_SIZE(voiceblue_config);
+ omap_serial_init();
+ omap_usb_init(&voiceblue_usb_config);
+ omap_register_i2c_bus(1, 100, NULL, 0);
/* There is a good chance board is going up, so enable power LED
* (it is connected through invertor) */
omap_writeb(0x00, OMAP_LPG1_PMR); /* Disable clock */
}
-static int __initdata omap_serial_ports[OMAP_MAX_NR_PORTS] = {1, 1, 1};
-
static void __init voiceblue_map_io(void)
{
- omap_map_common_io();
- omap_serial_init(omap_serial_ports);
+ omap1_map_common_io();
}
#define MACHINE_PANICED 1
static int __init voiceblue_setup(void)
{
/* Setup panic notifier */
- notifier_chain_register(&panic_notifier_list, &panic_block);
+ atomic_notifier_chain_register(&panic_notifier_list, &panic_block);
return 0;
}
void voiceblue_wdt_enable(void)
{
- omap_set_gpio_direction(0, 0);
- omap_set_gpio_dataout(0, 0);
- omap_set_gpio_dataout(0, 1);
- omap_set_gpio_dataout(0, 0);
+ gpio_direction_output(0, 0);
+ gpio_set_value(0, 1);
+ gpio_set_value(0, 0);
wdt_gpio_state = 0;
}
void voiceblue_wdt_disable(void)
{
- omap_set_gpio_dataout(0, 0);
- omap_set_gpio_dataout(0, 1);
- omap_set_gpio_dataout(0, 0);
- omap_set_gpio_direction(0, 1);
+ gpio_set_value(0, 0);
+ gpio_set_value(0, 1);
+ gpio_set_value(0, 0);
+ gpio_direction_input(0);
}
void voiceblue_wdt_ping(void)
return;
wdt_gpio_state = !wdt_gpio_state;
- omap_set_gpio_dataout(0, wdt_gpio_state);
+ gpio_set_value(0, wdt_gpio_state);
}
void voiceblue_reset(void)
MACHINE_START(VOICEBLUE, "VoiceBlue OMAP5910")
/* Maintainer: Ladislav Michl <michl@2n.cz> */
- .phys_ram = 0x10000000,
.phys_io = 0xfff00000,
.io_pg_offst = ((0xfef00000) >> 18) & 0xfffc,
.boot_params = 0x10000100,
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff