netns xfrm: fix "ip xfrm state|policy count" misreport

[safe/jmp/linux-2.6] / arch / arm / mach-kirkwood / sheevaplug-setup.c

diff --git a/arch/arm/mach-kirkwood/sheevaplug-setup.c b/arch/arm/mach-kirkwood/sheevaplug-setup.c
index dcc448c..c7319ee 100644 (file)
--- a/arch/arm/mach-kirkwood/sheevaplug-setup.c
+++ b/arch/arm/mach-kirkwood/sheevaplug-setup.c
@@ -11,7 +11,6 @@
 #include <linux/kernel.h>
 #include <linux/init.h>
 #include <linux/platform_device.h>
-#include <linux/mtd/nand.h>
 #include <linux/mtd/partitions.h>
 #include <linux/mv643xx_eth.h>
 #include <linux/gpio.h>
@@ -20,7 +19,6 @@
 #include <asm/mach/arch.h>
 #include <mach/kirkwood.h>
 #include <plat/mvsdio.h>
-#include <plat/orion_nand.h>
 #include "common.h"
 #include "mpp.h"
 
@@ -40,32 +38,6 @@ static struct mtd_partition sheevaplug_nand_parts[] = {
        },
 };
 
-static struct resource sheevaplug_nand_resource = {
-       .flags          = IORESOURCE_MEM,
-       .start          = KIRKWOOD_NAND_MEM_PHYS_BASE,
-       .end            = KIRKWOOD_NAND_MEM_PHYS_BASE +
-                         KIRKWOOD_NAND_MEM_SIZE - 1,
-};
-
-static struct orion_nand_data sheevaplug_nand_data = {
-       .parts          = sheevaplug_nand_parts,
-       .nr_parts       = ARRAY_SIZE(sheevaplug_nand_parts),
-       .cle            = 0,
-       .ale            = 1,
-       .width          = 8,
-       .chip_delay     = 25,
-};
-
-static struct platform_device sheevaplug_nand_flash = {
-       .name           = "orion_nand",
-       .id             = -1,
-       .dev            = {
-               .platform_data  = &sheevaplug_nand_data,
-       },
-       .resource       = &sheevaplug_nand_resource,
-       .num_resources  = 1,
-};
-
 static struct mv643xx_eth_platform_data sheevaplug_ge00_data = {
        .phy_addr       = MV643XX_ETH_PHY_ADDR(0),
 };
@@ -111,6 +83,7 @@ static void __init sheevaplug_init(void)
        kirkwood_mpp_conf(sheevaplug_mpp_config);
 
        kirkwood_uart0_init();
+       kirkwood_nand_init(ARRAY_AND_SIZE(sheevaplug_nand_parts), 25);
 
        if (gpio_request(29, "USB Power Enable") != 0 ||
            gpio_direction_output(29, 1) != 0)
@@ -120,7 +93,6 @@ static void __init sheevaplug_init(void)
        kirkwood_ge00_init(&sheevaplug_ge00_data);
        kirkwood_sdio_init(&sheevaplug_mvsdio_data);
 
-       platform_device_register(&sheevaplug_nand_flash);
        platform_device_register(&sheevaplug_leds);
 }