[ARM] 4907/1: [AT91] SAM9/CAP9 reset reason

[safe/jmp/linux-2.6] / arch / arm / mach-at91 / board-sam9rlek.c

diff --git a/arch/arm/mach-at91/board-sam9rlek.c b/arch/arm/mach-at91/board-sam9rlek.c
index 9b61320..ffc0597 100644 (file)
--- a/arch/arm/mach-at91/board-sam9rlek.c
+++ b/arch/arm/mach-at91/board-sam9rlek.c
@@ -29,29 +29,24 @@
 
 #include <asm/arch/board.h>
 #include <asm/arch/gpio.h>
-#include <asm/arch/at91sam926x_mc.h>
+#include <asm/arch/at91sam9_smc.h>
 
 #include "generic.h"
 
 
-/*
- * Serial port configuration.
- *    0 .. 3 = USART0 .. USART3
- *    4      = DBGU
- */
-static struct at91_uart_config __initdata ek_uart_config = {
-       .console_tty    = 0,                            /* ttyS0 */
-       .nr_tty         = 2,
-       .tty_map        = { 4, 0, -1, -1, -1 }          /* ttyS0, ..., ttyS4 */
-};
-
 static void __init ek_map_io(void)
 {
        /* Initialize processor: 12.000 MHz crystal */
        at91sam9rl_initialize(12000000);
 
-       /* Setup the serial ports and console */
-       at91_init_serial(&ek_uart_config);
+       /* DGBU on ttyS0. (Rx & Tx only) */
+       at91_register_uart(0, 0, 0);
+
+       /* USART0 on ttyS1. (Rx, Tx, CTS, RTS) */
+       at91_register_uart(AT91SAM9RL_ID_US0, 1, ATMEL_UART_CTS | ATMEL_UART_RTS);
+
+       /* set serial console to ttyS0 (ie, DBGU) */
+       at91_set_serial_console(0);
 }
 
 static void __init ek_init_irq(void)
@@ -181,7 +176,7 @@ static void __init ek_board_init(void)
        /* Serial */
        at91_add_device_serial();
        /* I2C */
-       at91_add_device_i2c();
+       at91_add_device_i2c(NULL, 0);
        /* NAND */
        at91_add_device_nand(&ek_nand_data);
        /* SPI */