[ARM] 5260/1: [AT91] Touchscreen on AT91SAM9RL

[safe/jmp/linux-2.6] / arch / arm / mach-at91 / board-csb637.c

diff --git a/arch/arm/mach-at91/board-csb637.c b/arch/arm/mach-at91/board-csb637.c
index 26cda43..cfa3f04 100644 (file)
--- a/arch/arm/mach-at91/board-csb637.c
+++ b/arch/arm/mach-at91/board-csb637.c
@@ -25,7 +25,6 @@
 #include <linux/platform_device.h>
 #include <linux/mtd/physmap.h>
 
-#include <asm/hardware.h>
 #include <asm/setup.h>
 #include <asm/mach-types.h>
 #include <asm/irq.h>
@@ -34,8 +33,9 @@
 #include <asm/mach/map.h>
 #include <asm/mach/irq.h>
 
-#include <asm/arch/board.h>
-#include <asm/arch/gpio.h>
+#include <mach/hardware.h>
+#include <mach/board.h>
+#include <mach/gpio.h>
 
 #include "generic.h"
 
@@ -45,13 +45,10 @@ static void __init csb637_map_io(void)
        /* Initialize processor: 3.6864 MHz crystal */
        at91rm9200_initialize(3686400, AT91RM9200_BGA);
 
-       /* Setup the LEDs */
-       at91_init_leds(AT91_PIN_PB2, AT91_PIN_PB2);
-
-       /* DBGU on ttyS0 */
+       /* DBGU on ttyS0. (Rx & Tx only) */
        at91_register_uart(0, 0, 0);
 
-       /* make console=ttyS0 the default */
+       /* make console=ttyS0 (ie, DBGU) the default */
        at91_set_serial_console(0);
 }
 
@@ -75,7 +72,7 @@ static struct at91_udc_data __initdata csb637_udc_data = {
 };
 
 #define CSB_FLASH_BASE AT91_CHIPSELECT_0
-#define CSB_FLASH_SIZE 0x1000000
+#define CSB_FLASH_SIZE SZ_16M
 
 static struct mtd_partition csb_flash_partitions[] = {
        {
@@ -110,8 +107,19 @@ static struct platform_device csb_flash = {
        .num_resources  = ARRAY_SIZE(csb_flash_resources),
 };
 
+static struct gpio_led csb_leds[] = {
+       {       /* "d1", red */
+               .name                   = "d1",
+               .gpio                   = AT91_PIN_PB2,
+               .active_low             = 1,
+               .default_trigger        = "heartbeat",
+       },
+};
+
 static void __init csb637_board_init(void)
 {
+       /* LED(s) */
+       at91_gpio_leds(csb_leds, ARRAY_SIZE(csb_leds));
        /* Serial */
        at91_add_device_serial();
        /* Ethernet */