ext4: Update documentation about quota mount options

[safe/jmp/linux-2.6] / Documentation / networking / README.ipw2200

diff --git a/Documentation/networking/README.ipw2200 b/Documentation/networking/README.ipw2200
index 712c568..80c7285 100644 (file)
--- a/Documentation/networking/README.ipw2200
+++ b/Documentation/networking/README.ipw2200
@@ -10,12 +10,12 @@ both hardware adapters listed above. In this document the Intel(R)
 PRO/Wireless 2915ABG Driver for Linux will be used to reference the
 unified driver.
 
-Copyright (C) 2004-2005, Intel Corporation
+Copyright (C) 2004-2006, Intel Corporation
 
 README.ipw2200
 
-Version: 1.0.8
-Date   : October 20, 2005
+Version: 1.1.2
+Date   : March 30, 2006
 
 
 Index
@@ -30,6 +30,7 @@ Index
 2.   Ad-Hoc Networking
 3.   Interacting with Wireless Tools
 3.1. iwconfig mode
+3.2. iwconfig sens
 4.   About the Version Numbers
 5.   Firmware installation
 6.   Support
@@ -102,7 +103,7 @@ file.
 
 1.1. Overview of Features
 -----------------------------------------------
-The current release (1.0.8) supports the following features:
+The current release (1.1.2) supports the following features:
 
 + BSS mode (Infrastructure, Managed)
 + IBSS mode (Ad-Hoc)
@@ -146,7 +147,7 @@ Where the supported parameter are:
        driver.  If disabled, the driver will not attempt to scan 
        for and associate to a network until it has been configured with 
        one or more properties for the target network, for example configuring 
-       the network SSID.  Default is 1 (auto-associate)
+       the network SSID.  Default is 0 (do not auto-associate)
        
        Example: % modprobe ipw2200 associate=0
 
@@ -246,8 +247,8 @@ and can set the contents via echo.  For example:
 % cat /sys/bus/pci/drivers/ipw2200/debug_level
 
 Will report the current debug level of the driver's logging subsystem 
-(only available if CONFIG_IPW_DEBUG was configured when the driver was 
-built).
+(only available if CONFIG_IPW2200_DEBUG was configured when the driver
+was built).
 
 You can set the debug level via:
 
@@ -383,6 +384,15 @@ When configuring the mode of the adapter, all run-time configured parameters
 are reset to the value used when the module was loaded.  This includes
 channels, rates, ESSID, etc.
 
+3.2 iwconfig sens
+-----------------------------------------------
+
+The 'iwconfig ethX sens XX' command will not set the signal sensitivity
+threshold, as described in iwconfig documentation, but rather the number
+of consecutive missed beacons that will trigger handover, i.e. roaming
+to another access point. At the same time, it will set the disassociation
+threshold to 3 times the given value.
+
 
 4.   About the Version Numbers
 -----------------------------------------------
@@ -438,7 +448,7 @@ For general information and support, go to:
 7.  License
 -----------------------------------------------
 
-  Copyright(c) 2003 - 2005 Intel Corporation. All rights reserved.
+  Copyright(c) 2003 - 2006 Intel Corporation. All rights reserved.
 
   This program is free software; you can redistribute it and/or modify it 
   under the terms of the GNU General Public License version 2 as