V4L/DVB (13347): cx23885: add digital television support for Hauppauge WinTV-HVR1290

[safe/jmp/linux-2.6] / Documentation / kernel-parameters.txt

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index c8d1b2b..51138b3 100644 (file)
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -85,7 +85,6 @@ parameter is applicable:
        PPT     Parallel port support is enabled.
        PS2     Appropriate PS/2 support is enabled.
        RAM     RAM disk support is enabled.
-       ROOTPLUG The example Root Plug LSM is enabled.
        S390    S390 architecture is enabled.
        SCSI    Appropriate SCSI support is enabled.
                        A lot of drivers has their options described inside of
@@ -2039,8 +2038,15 @@ and is between 256 and 4096 characters. It is defined in the file
 
        print-fatal-signals=
                        [KNL] debug: print fatal signals
-                       print-fatal-signals=1: print segfault info to
-                       the kernel console.
+
+                       If enabled, warn about various signal handling
+                       related application anomalies: too many signals,
+                       too many POSIX.1 timers, fatal signals causing a
+                       coredump - etc.
+
+                       If you hit the warning due to signal overflow,
+                       you might want to try "ulimit -i unlimited".
+
                        default: off.
 
        printk.time=    Show timing data prefixed to each printk message line
@@ -2171,15 +2177,6 @@ and is between 256 and 4096 characters. It is defined in the file
                        Useful for devices that are detected asynchronously
                        (e.g. USB and MMC devices).
 
-       root_plug.vendor_id=
-                       [ROOTPLUG] Override the default vendor ID
-
-       root_plug.product_id=
-                       [ROOTPLUG] Override the default product ID
-
-       root_plug.debug=
-                       [ROOTPLUG] Enable debugging output
-
        rw              [KNL] Mount root device read-write on boot
 
        S               [KNL] Run init in single mode