page-types: whitespace alignment

[safe/jmp/linux-2.6] / Documentation / arm / Interrupts

diff --git a/Documentation/arm/Interrupts b/Documentation/arm/Interrupts
index 72c93de..f09ab1b 100644 (file)
--- a/Documentation/arm/Interrupts
+++ b/Documentation/arm/Interrupts
@@ -138,18 +138,12 @@ So, what's changed?
 
                 Set active the IRQ edge(s)/level.  This replaces the
                 SA1111 INTPOL manipulation, and the set_GPIO_IRQ_edge()
-                function.  Type should be one of the following:
-
-                #define IRQT_NOEDGE     (0)
-                #define IRQT_RISING     (__IRQT_RISEDGE)
-                #define IRQT_FALLING    (__IRQT_FALEDGE)
-                #define IRQT_BOTHEDGE   (__IRQT_RISEDGE|__IRQT_FALEDGE)
-                #define IRQT_LOW        (__IRQT_LOWLVL)
-                #define IRQT_HIGH       (__IRQT_HIGHLVL)
+                function.  Type should be one of IRQ_TYPE_xxx defined in
+               <linux/irq.h>
 
 3. set_GPIO_IRQ_edge() is obsolete, and should be replaced by set_irq_type.
 
-4. Direct access to SA1111 INTPOL is depreciated.  Use set_irq_type instead.
+4. Direct access to SA1111 INTPOL is deprecated.  Use set_irq_type instead.
 
 5. A handler is expected to perform any necessary acknowledgement of the
    parent IRQ via the correct chip specific function.  For instance, if
@@ -164,7 +158,7 @@ So, what's changed?
    be re-checked for pending events.  (see the Neponset IRQ handler for
    details).
 
-7. fixup_irq() is gone, as is include/asm-arm/arch-*/irq.h
+7. fixup_irq() is gone, as is arch/arm/mach-*/include/mach/irq.h
 
 Please note that this will not solve all problems - some of them are
 hardware based.  Mixing level-based and edge-based IRQs on the same