-/*
- * ieee80211_enable_ht should be called only after the operating band
- * has been determined as ht configuration depends on the hw's
- * HT abilities for a specific band.
- */
-u32 ieee80211_enable_ht(struct ieee80211_sub_if_data *sdata,
- struct ieee80211_ht_info *hti,
- u16 ap_ht_cap_flags)
-{
- struct ieee80211_local *local = sdata->local;
- struct ieee80211_supported_band *sband;
- struct ieee80211_bss_ht_conf ht;
- u32 changed = 0;
- bool enable_ht = true, ht_changed;
- enum nl80211_channel_type channel_type = NL80211_CHAN_NO_HT;
-
- sband = local->hw.wiphy->bands[local->hw.conf.channel->band];
-
- memset(&ht, 0, sizeof(ht));
-
- /* HT is not supported */
- if (!sband->ht_cap.ht_supported)
- enable_ht = false;
-
- /* check that channel matches the right operating channel */
- if (local->hw.conf.channel->center_freq !=
- ieee80211_channel_to_frequency(hti->control_chan))
- enable_ht = false;
-
- if (enable_ht) {
- channel_type = NL80211_CHAN_HT20;
-
- if (!(ap_ht_cap_flags & IEEE80211_HT_CAP_40MHZ_INTOLERANT) &&
- (sband->ht_cap.cap & IEEE80211_HT_CAP_SUP_WIDTH_20_40) &&
- (hti->ht_param & IEEE80211_HT_PARAM_CHAN_WIDTH_ANY)) {
- switch(hti->ht_param & IEEE80211_HT_PARAM_CHA_SEC_OFFSET) {
- case IEEE80211_HT_PARAM_CHA_SEC_ABOVE:
- channel_type = NL80211_CHAN_HT40PLUS;
- break;
- case IEEE80211_HT_PARAM_CHA_SEC_BELOW:
- channel_type = NL80211_CHAN_HT40MINUS;
- break;
- }
- }
- }
-
- ht_changed = conf_is_ht(&local->hw.conf) != enable_ht ||
- channel_type != local->hw.conf.channel_type;
-
- local->oper_channel_type = channel_type;
-
- if (ht_changed) {
- /* channel_type change automatically detected */
- ieee80211_hw_config(local, 0);
- }
-
- /* disable HT */
- if (!enable_ht)
- return 0;
-
- ht.operation_mode = le16_to_cpu(hti->operation_mode);
-
- /* if bss configuration changed store the new one */
- if (memcmp(&sdata->vif.bss_conf.ht, &ht, sizeof(ht))) {
- changed |= BSS_CHANGED_HT;
- sdata->vif.bss_conf.ht = ht;
- }
-
- return changed;
-}
-