+ int (*bus_suspend)(struct usb_hcd *);
+ int (*bus_resume)(struct usb_hcd *);
+ int (*start_port_reset)(struct usb_hcd *, unsigned port_num);
+
+ /* force handover of high-speed port to full-speed companion */
+ void (*relinquish_port)(struct usb_hcd *, int);
+ /* has a port been handed over to a companion? */
+ int (*port_handed_over)(struct usb_hcd *, int);
+
+ /* CLEAR_TT_BUFFER completion callback */
+ void (*clear_tt_buffer_complete)(struct usb_hcd *,
+ struct usb_host_endpoint *);
+
+ /* xHCI specific functions */
+ /* Called by usb_alloc_dev to alloc HC device structures */
+ int (*alloc_dev)(struct usb_hcd *, struct usb_device *);
+ /* Called by usb_disconnect to free HC device structures */
+ void (*free_dev)(struct usb_hcd *, struct usb_device *);
+
+ /* Bandwidth computation functions */
+ /* Note that add_endpoint() can only be called once per endpoint before
+ * check_bandwidth() or reset_bandwidth() must be called.
+ * drop_endpoint() can only be called once per endpoint also.
+ * A call to xhci_drop_endpoint() followed by a call to xhci_add_endpoint() will
+ * add the endpoint to the schedule with possibly new parameters denoted by a
+ * different endpoint descriptor in usb_host_endpoint.
+ * A call to xhci_add_endpoint() followed by a call to xhci_drop_endpoint() is
+ * not allowed.
+ */
+ /* Allocate endpoint resources and add them to a new schedule */
+ int (*add_endpoint)(struct usb_hcd *, struct usb_device *, struct usb_host_endpoint *);
+ /* Drop an endpoint from a new schedule */
+ int (*drop_endpoint)(struct usb_hcd *, struct usb_device *, struct usb_host_endpoint *);
+ /* Check that a new hardware configuration, set using
+ * endpoint_enable and endpoint_disable, does not exceed bus
+ * bandwidth. This must be called before any set configuration
+ * or set interface requests are sent to the device.
+ */
+ int (*check_bandwidth)(struct usb_hcd *, struct usb_device *);
+ /* Reset the device schedule to the last known good schedule,
+ * which was set from a previous successful call to
+ * check_bandwidth(). This reverts any add_endpoint() and
+ * drop_endpoint() calls since that last successful call.
+ * Used for when a check_bandwidth() call fails due to resource
+ * or bandwidth constraints.
+ */
+ void (*reset_bandwidth)(struct usb_hcd *, struct usb_device *);
+ /* Returns the hardware-chosen device address */
+ int (*address_device)(struct usb_hcd *, struct usb_device *udev);
+ /* Notifies the HCD after a hub descriptor is fetched.
+ * Will block.
+ */
+ int (*update_hub_device)(struct usb_hcd *, struct usb_device *hdev,
+ struct usb_tt *tt, gfp_t mem_flags);
+ int (*reset_device)(struct usb_hcd *, struct usb_device *);