+ Driver for the internal RTC (Realtime Clock) on Atmel AVR32
+ AT32AP700x family processors.
+
+config RTC_DRV_AT91RM9200
+ tristate "AT91RM9200 or AT91SAM9RL"
+ depends on ARCH_AT91RM9200 || ARCH_AT91SAM9RL
+ help
+ Driver for the internal RTC (Realtime Clock) module found on
+ Atmel AT91RM9200's and AT91SAM9RL chips. On SAM9RL chips
+ this is powered by the backup power supply.
+
+config RTC_DRV_AT91SAM9
+ tristate "AT91SAM9x/AT91CAP9"
+ depends on ARCH_AT91 && !(ARCH_AT91RM9200 || ARCH_AT91X40)
+ help
+ RTC driver for the Atmel AT91SAM9x and AT91CAP9 internal RTT
+ (Real Time Timer). These timers are powered by the backup power
+ supply (such as a small coin cell battery), but do not need to
+ be used as RTCs.
+
+ (On AT91SAM9rl chips you probably want to use the dedicated RTC
+ module and leave the RTT available for other uses.)
+
+config RTC_DRV_AT91SAM9_RTT
+ int
+ range 0 1
+ default 0
+ prompt "RTT module Number" if ARCH_AT91SAM9263
+ depends on RTC_DRV_AT91SAM9
+ help
+ More than one RTT module is available. You can choose which
+ one will be used as an RTC. The default of zero is normally
+ OK to use, though some systems use that for non-RTC purposes.
+
+config RTC_DRV_AT91SAM9_GPBR
+ int
+ range 0 3 if !ARCH_AT91SAM9263
+ range 0 15 if ARCH_AT91SAM9263
+ default 0
+ prompt "Backup Register Number"
+ depends on RTC_DRV_AT91SAM9
+ help
+ The RTC driver needs to use one of the General Purpose Backup
+ Registers (GPBRs) as well as the RTT. You can choose which one
+ will be used. The default of zero is normally OK to use, but
+ on some systems other software needs to use that register.