-static int rtl_eeprom_read(struct pci_dev *pdev, int cap, int addr, __le32 *val)
-{
- int ret, count = 100;
- u16 status = 0;
- u32 value;
-
- ret = pci_write_config_word(pdev, cap + PCI_VPD_ADDR, addr);
- if (ret < 0)
- return ret;
-
- do {
- udelay(10);
- ret = pci_read_config_word(pdev, cap + PCI_VPD_ADDR, &status);
- if (ret < 0)
- return ret;
- } while (!(status & PCI_VPD_ADDR_F) && --count);
-
- if (!(status & PCI_VPD_ADDR_F))
- return -ETIMEDOUT;
-
- ret = pci_read_config_dword(pdev, cap + PCI_VPD_DATA, &value);
- if (ret < 0)
- return ret;
-
- *val = cpu_to_le32(value);
-
- return 0;
-}
-
-static void rtl_init_mac_address(struct rtl8169_private *tp,
- void __iomem *ioaddr)
-{
- struct pci_dev *pdev = tp->pci_dev;
- u8 cfg1;
- int vpd_cap;
- u8 mac[8];
- DECLARE_MAC_BUF(buf);
-
- cfg1 = RTL_R8(Config1);
- if (!(cfg1 & VPD)) {
- dprintk("VPD access not enabled, enabling\n");
- RTL_W8(Cfg9346, Cfg9346_Unlock);
- RTL_W8(Config1, cfg1 | VPD);
- RTL_W8(Cfg9346, Cfg9346_Lock);
- }
-
- vpd_cap = pci_find_capability(pdev, PCI_CAP_ID_VPD);
- if (!vpd_cap)
- return;
-
- /* MAC address is stored in EEPROM at offset 0x0e
- * Realtek says: "The VPD address does not have to be a DWORD-aligned
- * address as defined in the PCI 2.2 Specifications, but the VPD data
- * is always consecutive 4-byte data starting from the VPD address
- * specified."
- */
- if (rtl_eeprom_read(pdev, vpd_cap, 0x000e, (__le32*)&mac[0]) < 0 ||
- rtl_eeprom_read(pdev, vpd_cap, 0x0012, (__le32*)&mac[4]) < 0) {
- dprintk("Reading MAC address from EEPROM failed\n");
- return;
- }
-
- dprintk("MAC address found in EEPROM: %s\n", print_mac(buf, mac));
+static const struct net_device_ops rtl8169_netdev_ops = {
+ .ndo_open = rtl8169_open,
+ .ndo_stop = rtl8169_close,
+ .ndo_get_stats = rtl8169_get_stats,
+ .ndo_start_xmit = rtl8169_start_xmit,
+ .ndo_tx_timeout = rtl8169_tx_timeout,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_change_mtu = rtl8169_change_mtu,
+ .ndo_set_mac_address = rtl_set_mac_address,
+ .ndo_do_ioctl = rtl8169_ioctl,
+ .ndo_set_multicast_list = rtl_set_rx_mode,
+#ifdef CONFIG_R8169_VLAN
+ .ndo_vlan_rx_register = rtl8169_vlan_rx_register,
+#endif
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = rtl8169_netpoll,
+#endif