+ return count;
+}
+
+/**
+ * igb_set_rx_mode - Secondary Unicast, Multicast and Promiscuous mode set
+ * @netdev: network interface device structure
+ *
+ * The set_rx_mode entry point is called whenever the unicast or multicast
+ * address lists or the network interface flags are updated. This routine is
+ * responsible for configuring the hardware for proper unicast, multicast,
+ * promiscuous mode, and all-multi behavior.
+ **/
+static void igb_set_rx_mode(struct net_device *netdev)
+{
+ struct igb_adapter *adapter = netdev_priv(netdev);
+ struct e1000_hw *hw = &adapter->hw;
+ unsigned int vfn = adapter->vfs_allocated_count;
+ u32 rctl, vmolr = 0;
+ int count;
+
+ /* Check for Promiscuous and All Multicast modes */
+ rctl = rd32(E1000_RCTL);
+
+ /* clear the effected bits */
+ rctl &= ~(E1000_RCTL_UPE | E1000_RCTL_MPE | E1000_RCTL_VFE);
+
+ if (netdev->flags & IFF_PROMISC) {
+ rctl |= (E1000_RCTL_UPE | E1000_RCTL_MPE);
+ vmolr |= (E1000_VMOLR_ROPE | E1000_VMOLR_MPME);
+ } else {
+ if (netdev->flags & IFF_ALLMULTI) {
+ rctl |= E1000_RCTL_MPE;
+ vmolr |= E1000_VMOLR_MPME;
+ } else {
+ /*
+ * Write addresses to the MTA, if the attempt fails
+ * then we should just turn on promiscous mode so
+ * that we can at least receive multicast traffic
+ */
+ count = igb_write_mc_addr_list(netdev);
+ if (count < 0) {
+ rctl |= E1000_RCTL_MPE;
+ vmolr |= E1000_VMOLR_MPME;
+ } else if (count) {
+ vmolr |= E1000_VMOLR_ROMPE;
+ }
+ }
+ /*
+ * Write addresses to available RAR registers, if there is not
+ * sufficient space to store all the addresses then enable
+ * unicast promiscous mode
+ */
+ count = igb_write_uc_addr_list(netdev);
+ if (count < 0) {
+ rctl |= E1000_RCTL_UPE;
+ vmolr |= E1000_VMOLR_ROPE;
+ }
+ rctl |= E1000_RCTL_VFE;