+config MTD_NAND_ATMEL
+ tristate "Support for NAND Flash / SmartMedia on AT91 and AVR32"
+ depends on ARCH_AT91 || AVR32
+ help
+ Enables support for NAND Flash / Smart Media Card interface
+ on Atmel AT91 and AVR32 processors.
+choice
+ prompt "ECC management for NAND Flash / SmartMedia on AT91 / AVR32"
+ depends on MTD_NAND_ATMEL
+
+config MTD_NAND_ATMEL_ECC_HW
+ bool "Hardware ECC"
+ depends on ARCH_AT91SAM9263 || ARCH_AT91SAM9260 || AVR32
+ help
+ Use hardware ECC instead of software ECC when the chip
+ supports it.
+
+ The hardware ECC controller is capable of single bit error
+ correction and 2-bit random detection per page.
+
+ NB : hardware and software ECC schemes are incompatible.
+ If you switch from one to another, you'll have to erase your
+ mtd partition.
+
+ If unsure, say Y
+
+config MTD_NAND_ATMEL_ECC_SOFT
+ bool "Software ECC"
+ help
+ Use software ECC.
+
+ NB : hardware and software ECC schemes are incompatible.
+ If you switch from one to another, you'll have to erase your
+ mtd partition.
+
+config MTD_NAND_ATMEL_ECC_NONE
+ bool "No ECC (testing only, DANGEROUS)"
+ depends on DEBUG_KERNEL
+ help
+ No ECC will be used.
+ It's not a good idea and it should be reserved for testing
+ purpose only.
+
+ If unsure, say N
+
+ endchoice
+
+endchoice
+
+config MTD_NAND_PXA3xx
+ bool "Support for NAND flash devices on PXA3xx"
+ depends on MTD_NAND && PXA3xx
+ help
+ This enables the driver for the NAND flash device found on
+ PXA3xx processors
+
+config MTD_NAND_CM_X270
+ tristate "Support for NAND Flash on CM-X270 modules"
+ depends on MTD_NAND && MACH_ARMCORE
+
+config MTD_NAND_PASEMI
+ tristate "NAND support for PA Semi PWRficient"
+ depends on MTD_NAND && PPC_PASEMI
+ help
+ Enables support for NAND Flash interface on PA Semi PWRficient
+ based boards
+
+config MTD_NAND_TMIO
+ tristate "NAND Flash device on Toshiba Mobile IO Controller"
+ depends on MTD_NAND && MFD_TMIO
+ help
+ Support for NAND flash connected to a Toshiba Mobile IO
+ Controller in some PDAs, including the Sharp SL6000x.
+