- struct ide_disk_obj *idkp = to_ide_disk(kref);
- ide_drive_t *drive = idkp->drive;
- struct gendisk *g = idkp->disk;
-
- drive->driver_data = NULL;
- g->private_data = NULL;
- put_disk(g);
- kfree(idkp);
-}
-
-static int ide_disk_probe(ide_drive_t *drive);
-
-/*
- * On HPA drives the capacity needs to be
- * reinitilized on resume otherwise the disk
- * can not be used and a hard reset is required
- */
-static void ide_disk_resume(ide_drive_t *drive)
-{
- if (ata_id_hpa_enabled(drive->id))
- init_idedisk_capacity(drive);
-}
-
-static void ide_device_shutdown(ide_drive_t *drive)
-{
-#ifdef CONFIG_ALPHA
- /* On Alpha, halt(8) doesn't actually turn the machine off,
- it puts you into the sort of firmware monitor. Typically,
- it's used to boot another kernel image, so it's not much
- different from reboot(8). Therefore, we don't need to
- spin down the disk in this case, especially since Alpha
- firmware doesn't handle disks in standby mode properly.
- On the other hand, it's reasonably safe to turn the power
- off when the shutdown process reaches the firmware prompt,
- as the firmware initialization takes rather long time -
- at least 10 seconds, which should be sufficient for
- the disk to expire its write cache. */
- if (system_state != SYSTEM_POWER_OFF) {
-#else
- if (system_state == SYSTEM_RESTART) {
-#endif
- ide_cacheflush_p(drive);
- return;
- }
-
- printk(KERN_INFO "Shutdown: %s\n", drive->name);
-
- drive->gendev.bus->suspend(&drive->gendev, PMSG_SUSPEND);
-}
-
-static ide_driver_t idedisk_driver = {
- .gen_driver = {
- .owner = THIS_MODULE,
- .name = "ide-disk",
- .bus = &ide_bus_type,
- },
- .probe = ide_disk_probe,
- .remove = ide_disk_remove,
- .resume = ide_disk_resume,
- .shutdown = ide_device_shutdown,
- .version = IDEDISK_VERSION,
- .media = ide_disk,
- .do_request = ide_do_rw_disk,
- .end_request = ide_end_request,
- .error = __ide_error,
-#ifdef CONFIG_IDE_PROC_FS
- .proc = idedisk_proc,
- .settings = idedisk_settings,
-#endif
-};
-
-static int idedisk_set_doorlock(ide_drive_t *drive, int on)
-{
- ide_task_t task;
-
- memset(&task, 0, sizeof(task));
- task.tf.command = on ? ATA_CMD_MEDIA_LOCK : ATA_CMD_MEDIA_UNLOCK;
- task.tf_flags = IDE_TFLAG_TF | IDE_TFLAG_DEVICE;
-
- return ide_no_data_taskfile(drive, &task);
-}
-
-static int idedisk_open(struct inode *inode, struct file *filp)
-{
- struct gendisk *disk = inode->i_bdev->bd_disk;
- struct ide_disk_obj *idkp;
- ide_drive_t *drive;
-
- idkp = ide_disk_get(disk);
- if (idkp == NULL)
- return -ENXIO;
-
- drive = idkp->drive;
-
- idkp->openers++;
-
- if (drive->removable && idkp->openers == 1) {
- check_disk_change(inode->i_bdev);
- /*
- * Ignore the return code from door_lock,
- * since the open() has already succeeded,
- * and the door_lock is irrelevant at this point.
- */
- if (drive->doorlocking && idedisk_set_doorlock(drive, 1))
- drive->doorlocking = 0;
- }