+config PAGE_OFFSET
+ hex
+ default "0x80000000" if MMU && SUPERH32
+ default "0x20000000" if MMU && SUPERH64
+ default "0x00000000"
+
+config FORCE_MAX_ZONEORDER
+ int "Maximum zone order"
+ range 9 64 if PAGE_SIZE_16KB
+ default "9" if PAGE_SIZE_16KB
+ range 7 64 if PAGE_SIZE_64KB
+ default "7" if PAGE_SIZE_64KB
+ range 11 64
+ default "14" if !MMU
+ default "11"
+ help
+ The kernel memory allocator divides physically contiguous memory
+ blocks into "zones", where each zone is a power of two number of
+ pages. This option selects the largest power of two that the kernel
+ keeps in the memory allocator. If you need to allocate very large
+ blocks of physically contiguous memory, then you may need to
+ increase this value.
+
+ This config option is actually maximum order plus one. For example,
+ a value of 11 means that the largest free memory block is 2^10 pages.
+
+ The page size is not necessarily 4KB. Keep this in mind when
+ choosing a value for this option.
+
+config MEMORY_START
+ hex "Physical memory start address"
+ default "0x08000000"
+ ---help---
+ Computers built with Hitachi SuperH processors always
+ map the ROM starting at address zero. But the processor
+ does not specify the range that RAM takes.
+
+ The physical memory (RAM) start address will be automatically
+ set to 08000000. Other platforms, such as the Solution Engine
+ boards typically map RAM at 0C000000.
+
+ Tweak this only when porting to a new machine which does not
+ already have a defconfig. Changing it from the known correct
+ value on any of the known systems will only lead to disaster.
+
+config MEMORY_SIZE
+ hex "Physical memory size"
+ default "0x04000000"
+ help
+ This sets the default memory size assumed by your SH kernel. It can
+ be overridden as normal by the 'mem=' argument on the kernel command
+ line. If unsure, consult your board specifications or just leave it
+ as 0x04000000 which was the default value before this became
+ configurable.