-config PPC_970_NAP
- bool
- default n
-
-source "drivers/cpufreq/Kconfig"
-
-config CPU_FREQ_PMAC
- bool "Support for Apple PowerBooks"
- depends on CPU_FREQ && ADB_PMU && PPC32
- select CPU_FREQ_TABLE
- help
- This adds support for frequency switching on Apple PowerBooks,
- this currently includes some models of iBook & Titanium
- PowerBook.
-
-config CPU_FREQ_PMAC64
- bool "Support for some Apple G5s"
- depends on CPU_FREQ && PPC64
- select CPU_FREQ_TABLE
- help
- This adds support for frequency switching on Apple iMac G5,
- and some of the more recent desktop G5 machines as well.
-
-config PPC601_SYNC_FIX
- bool "Workarounds for PPC601 bugs"
- depends on 6xx && (PPC_PREP || PPC_PMAC)
- help
- Some versions of the PPC601 (the first PowerPC chip) have bugs which
- mean that extra synchronization instructions are required near
- certain instructions, typically those that make major changes to the
- CPU state. These extra instructions reduce performance slightly.
- If you say N here, these extra instructions will not be included,
- resulting in a kernel which will run faster but may not run at all
- on some systems with the PPC601 chip.
-
- If in doubt, say Y here.
-
-config TAU
- bool "On-chip CPU temperature sensor support"
- depends on 6xx
- help
- G3 and G4 processors have an on-chip temperature sensor called the
- 'Thermal Assist Unit (TAU)', which, in theory, can measure the on-die
- temperature within 2-4 degrees Celsius. This option shows the current
- on-die temperature in /proc/cpuinfo if the cpu supports it.
-
- Unfortunately, on some chip revisions, this sensor is very inaccurate
- and in many cases, does not work at all, so don't assume the cpu
- temp is actually what /proc/cpuinfo says it is.
-
-config TAU_INT
- bool "Interrupt driven TAU driver (DANGEROUS)"
- depends on TAU
- ---help---
- The TAU supports an interrupt driven mode which causes an interrupt
- whenever the temperature goes out of range. This is the fastest way
- to get notified the temp has exceeded a range. With this option off,
- a timer is used to re-check the temperature periodically.
-
- However, on some cpus it appears that the TAU interrupt hardware
- is buggy and can cause a situation which would lead unexplained hard
- lockups.
-
- Unless you are extending the TAU driver, or enjoy kernel/hardware
- debugging, leave this option off.
-
-config TAU_AVERAGE
- bool "Average high and low temp"
- depends on TAU
- ---help---
- The TAU hardware can compare the temperature to an upper and lower
- bound. The default behavior is to show both the upper and lower
- bound in /proc/cpuinfo. If the range is large, the temperature is
- either changing a lot, or the TAU hardware is broken (likely on some
- G4's). If the range is small (around 4 degrees), the temperature is
- relatively stable. If you say Y here, a single temperature value,
- halfway between the upper and lower bounds, will be reported in
- /proc/cpuinfo.
-
- If in doubt, say N here.
-
-config PPC_TODC
- depends on EMBEDDED6xx
- bool "Generic Time-of-day Clock (TODC) support"
- ---help---
- This adds support for many TODC/RTC chips.
-
-endmenu
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff