+ Currently only works with FLAT binaries.
+
+config EXCEPTION_L1_SCRATCH
+ bool "Locate exception stack in L1 Scratch Memory"
+ default n
+ depends on !APP_STACK_L1
+ help
+ Whenever an exception occurs, use the L1 Scratch memory for
+ stack storage. You cannot place the stacks of FLAT binaries
+ in L1 when using this option.
+
+ If you don't use L1 Scratch, then you should say Y here.
+
+comment "Speed Optimizations"
+config BFIN_INS_LOWOVERHEAD
+ bool "ins[bwl] low overhead, higher interrupt latency"
+ default y
+ help
+ Reads on the Blackfin are speculative. In Blackfin terms, this means
+ they can be interrupted at any time (even after they have been issued
+ on to the external bus), and re-issued after the interrupt occurs.
+ For memory - this is not a big deal, since memory does not change if
+ it sees a read.
+
+ If a FIFO is sitting on the end of the read, it will see two reads,
+ when the core only sees one since the FIFO receives both the read
+ which is cancelled (and not delivered to the core) and the one which
+ is re-issued (which is delivered to the core).
+
+ To solve this, interrupts are turned off before reads occur to
+ I/O space. This option controls which the overhead/latency of
+ controlling interrupts during this time
+ "n" turns interrupts off every read
+ (higher overhead, but lower interrupt latency)
+ "y" turns interrupts off every loop
+ (low overhead, but longer interrupt latency)
+
+ default behavior is to leave this set to on (type "Y"). If you are experiencing
+ interrupt latency issues, it is safe and OK to turn this off.
+
+endmenu