+- min_slab_ratio
+- min_unmapped_ratio
+- mmap_min_addr
+- nr_hugepages
+- nr_overcommit_hugepages
+- nr_pdflush_threads
+- nr_trim_pages (only if CONFIG_MMU=n)
+- numa_zonelist_order
+- oom_dump_tasks
+- oom_kill_allocating_task
+- overcommit_memory
+- overcommit_ratio
+- page-cluster
+- panic_on_oom
+- percpu_pagelist_fraction
+- stat_interval
+- swappiness
+- vfs_cache_pressure
+- zone_reclaim_mode
+
+
+==============================================================
+
+block_dump
+
+block_dump enables block I/O debugging when set to a nonzero value. More
+information on block I/O debugging is in Documentation/laptops/laptop-mode.txt.
+
+==============================================================
+
+dirty_background_bytes
+
+Contains the amount of dirty memory at which the pdflush background writeback
+daemon will start writeback.
+
+If dirty_background_bytes is written, dirty_background_ratio becomes a function
+of its value (dirty_background_bytes / the amount of dirtyable system memory).
+
+==============================================================
+
+dirty_background_ratio
+
+Contains, as a percentage of total system memory, the number of pages at which
+the pdflush background writeback daemon will start writing out dirty data.
+
+==============================================================
+
+dirty_bytes
+
+Contains the amount of dirty memory at which a process generating disk writes
+will itself start writeback.
+
+If dirty_bytes is written, dirty_ratio becomes a function of its value
+(dirty_bytes / the amount of dirtyable system memory).
+
+==============================================================
+
+dirty_expire_centisecs
+
+This tunable is used to define when dirty data is old enough to be eligible
+for writeout by the pdflush daemons. It is expressed in 100'ths of a second.
+Data which has been dirty in-memory for longer than this interval will be
+written out next time a pdflush daemon wakes up.
+
+==============================================================
+
+dirty_ratio
+
+Contains, as a percentage of total system memory, the number of pages at which
+a process which is generating disk writes will itself start writing out dirty
+data.
+
+==============================================================
+
+dirty_writeback_centisecs
+
+The pdflush writeback daemons will periodically wake up and write `old' data
+out to disk. This tunable expresses the interval between those wakeups, in
+100'ths of a second.
+
+Setting this to zero disables periodic writeback altogether.
+
+==============================================================
+
+drop_caches
+
+Writing to this will cause the kernel to drop clean caches, dentries and
+inodes from memory, causing that memory to become free.
+
+To free pagecache:
+ echo 1 > /proc/sys/vm/drop_caches
+To free dentries and inodes:
+ echo 2 > /proc/sys/vm/drop_caches
+To free pagecache, dentries and inodes:
+ echo 3 > /proc/sys/vm/drop_caches
+
+As this is a non-destructive operation and dirty objects are not freeable, the
+user should run `sync' first.
+
+==============================================================
+
+hugepages_treat_as_movable
+
+This parameter is only useful when kernelcore= is specified at boot time to
+create ZONE_MOVABLE for pages that may be reclaimed or migrated. Huge pages
+are not movable so are not normally allocated from ZONE_MOVABLE. A non-zero
+value written to hugepages_treat_as_movable allows huge pages to be allocated
+from ZONE_MOVABLE.
+
+Once enabled, the ZONE_MOVABLE is treated as an area of memory the huge
+pages pool can easily grow or shrink within. Assuming that applications are
+not running that mlock() a lot of memory, it is likely the huge pages pool
+can grow to the size of ZONE_MOVABLE by repeatedly entering the desired value
+into nr_hugepages and triggering page reclaim.
+
+==============================================================
+
+hugetlb_shm_group
+
+hugetlb_shm_group contains group id that is allowed to create SysV
+shared memory segment using hugetlb page.
+
+==============================================================
+
+laptop_mode
+
+laptop_mode is a knob that controls "laptop mode". All the things that are
+controlled by this knob are discussed in Documentation/laptops/laptop-mode.txt.
+
+==============================================================
+
+legacy_va_layout
+
+If non-zero, this sysctl disables the new 32-bit mmap mmap layout - the kernel
+will use the legacy (2.4) layout for all processes.
+
+==============================================================
+
+lowmem_reserve_ratio
+
+For some specialised workloads on highmem machines it is dangerous for
+the kernel to allow process memory to be allocated from the "lowmem"
+zone. This is because that memory could then be pinned via the mlock()
+system call, or by unavailability of swapspace.
+
+And on large highmem machines this lack of reclaimable lowmem memory
+can be fatal.
+
+So the Linux page allocator has a mechanism which prevents allocations
+which _could_ use highmem from using too much lowmem. This means that
+a certain amount of lowmem is defended from the possibility of being
+captured into pinned user memory.
+
+(The same argument applies to the old 16 megabyte ISA DMA region. This
+mechanism will also defend that region from allocations which could use
+highmem or lowmem).
+
+The `lowmem_reserve_ratio' tunable determines how aggressive the kernel is
+in defending these lower zones.
+
+If you have a machine which uses highmem or ISA DMA and your
+applications are using mlock(), or if you are running with no swap then
+you probably should change the lowmem_reserve_ratio setting.
+
+The lowmem_reserve_ratio is an array. You can see them by reading this file.
+-
+% cat /proc/sys/vm/lowmem_reserve_ratio
+256 256 32
+-
+Note: # of this elements is one fewer than number of zones. Because the highest
+ zone's value is not necessary for following calculation.
+
+But, these values are not used directly. The kernel calculates # of protection
+pages for each zones from them. These are shown as array of protection pages
+in /proc/zoneinfo like followings. (This is an example of x86-64 box).
+Each zone has an array of protection pages like this.
+
+-
+Node 0, zone DMA
+ pages free 1355
+ min 3
+ low 3
+ high 4
+ :
+ :
+ numa_other 0
+ protection: (0, 2004, 2004, 2004)
+ ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
+ pagesets
+ cpu: 0 pcp: 0
+ :
+-
+These protections are added to score to judge whether this zone should be used
+for page allocation or should be reclaimed.
+
+In this example, if normal pages (index=2) are required to this DMA zone and
+pages_high is used for watermark, the kernel judges this zone should not be
+used because pages_free(1355) is smaller than watermark + protection[2]
+(4 + 2004 = 2008). If this protection value is 0, this zone would be used for
+normal page requirement. If requirement is DMA zone(index=0), protection[0]
+(=0) is used.
+
+zone[i]'s protection[j] is calculated by following expression.
+
+(i < j):
+ zone[i]->protection[j]
+ = (total sums of present_pages from zone[i+1] to zone[j] on the node)
+ / lowmem_reserve_ratio[i];
+(i = j):
+ (should not be protected. = 0;
+(i > j):
+ (not necessary, but looks 0)
+
+The default values of lowmem_reserve_ratio[i] are
+ 256 (if zone[i] means DMA or DMA32 zone)
+ 32 (others).
+As above expression, they are reciprocal number of ratio.
+256 means 1/256. # of protection pages becomes about "0.39%" of total present
+pages of higher zones on the node.
+
+If you would like to protect more pages, smaller values are effective.
+The minimum value is 1 (1/1 -> 100%).
+
+==============================================================
+
+max_map_count:
+
+This file contains the maximum number of memory map areas a process
+may have. Memory map areas are used as a side-effect of calling
+malloc, directly by mmap and mprotect, and also when loading shared
+libraries.
+
+While most applications need less than a thousand maps, certain
+programs, particularly malloc debuggers, may consume lots of them,
+e.g., up to one or two maps per allocation.
+
+The default value is 65536.