- Each bit of the <int> indicates an ACPI debug level,
- which corresponds to the level in an ACPI_DEBUG_PRINT
- statement. After system has booted up, this mask
- can be set via /sys/module/acpi/parameters/debug_level.
-
- CONFIG_ACPI_DEBUG must be enabled for this to produce
- any output. The number can be in decimal or prefixed
- with 0x in hex. Some of these options produce so much
- output that the system is unusable.
-
- The following global components are defined by the
- ACPI CA:
- 0x01 error
- 0x02 warn
- 0x04 init
- 0x08 debug object
- 0x10 info
- 0x20 init names
- 0x40 parse
- 0x80 load
- 0x100 dispatch
- 0x200 execute
- 0x400 names
- 0x800 operation region
- 0x1000 bfield
- 0x2000 tables
- 0x4000 values
- 0x8000 objects
- 0x10000 resources
- 0x20000 user requests
- 0x40000 package
- The number can be in decimal or prefixed with 0x in hex.
- Warning: Many of these options can produce a lot of
- output and make your system unusable. Be very careful.
+ CONFIG_ACPI_DEBUG must be enabled to produce any ACPI
+ debug output. Bits in debug_layer correspond to a
+ _COMPONENT in an ACPI source file, e.g.,
+ #define _COMPONENT ACPI_PCI_COMPONENT
+ Bits in debug_level correspond to a level in
+ ACPI_DEBUG_PRINT statements, e.g.,
+ ACPI_DEBUG_PRINT((ACPI_DB_INFO, ...
+ The debug_level mask defaults to "info". See
+ Documentation/acpi/debug.txt for more information about
+ debug layers and levels.
+
+ Enable processor driver info messages:
+ acpi.debug_layer=0x20000000
+ Enable PCI/PCI interrupt routing info messages:
+ acpi.debug_layer=0x400000
+ Enable AML "Debug" output, i.e., stores to the Debug
+ object while interpreting AML:
+ acpi.debug_layer=0xffffffff acpi.debug_level=0x2
+ Enable all messages related to ACPI hardware:
+ acpi.debug_layer=0x2 acpi.debug_level=0xffffffff
+
+ Some values produce so much output that the system is
+ unusable. The "log_buf_len" parameter may be useful
+ if you need to capture more output.
+
+ acpi.power_nocheck= [HW,ACPI]
+ Format: 1/0 enable/disable the check of power state.
+ On some bogus BIOS the _PSC object/_STA object of
+ power resource can't return the correct device power
+ state. In such case it is unneccessary to check its
+ power state again in power transition.
+ 1 : disable the power state check