config GFS2_FS tristate "GFS2 file system support" depends on EXPERIMENTAL && (64BIT || LBDAF) select DLM if GFS2_FS_LOCKING_DLM select CONFIGFS_FS if GFS2_FS_LOCKING_DLM select SYSFS if GFS2_FS_LOCKING_DLM select IP_SCTP if DLM_SCTP select FS_POSIX_ACL select CRC32 select SLOW_WORK select QUOTA select QUOTACTL select FS_JOURNAL_INFO help A cluster filesystem. Allows a cluster of computers to simultaneously use a block device that is shared between them (with FC, iSCSI, NBD, etc...). GFS reads and writes to the block device like a local filesystem, but also uses a lock module to allow the computers coordinate their I/O so filesystem consistency is maintained. One of the nifty features of GFS is perfect consistency -- changes made to the filesystem on one machine show up immediately on all other machines in the cluster. To use the GFS2 filesystem in a cluster, you will need to enable the locking module below. Documentation and utilities for GFS2 can be found here: http://sources.redhat.com/cluster The "nolock" lock module is now built in to GFS2 by default. If you want to use the DLM, be sure to enable HOTPLUG and IPv4/6 networking. config GFS2_FS_LOCKING_DLM bool "GFS2 DLM locking" depends on (GFS2_FS!=n) && NET && INET && (IPV6 || IPV6=n) && HOTPLUG help Multiple node locking module for GFS2 Most users of GFS2 will require this. It provides the locking interface between GFS2 and the DLM, which is required to use GFS2 in a cluster environment.