Phonet: kernel documentation
[safe/jmp/linux-2.6] / Documentation / networking / phonet.txt
1 Linux Phonet protocol family
2 ============================
3
4 Introduction
5 ------------
6
7 Phonet is a packet protocol used by Nokia cellular modems for both IPC
8 and RPC. With the Linux Phonet socket family, Linux host processes can
9 receive and send messages from/to the modem, or any other external
10 device attached to the modem. The modem takes care of routing.
11
12 Phonet packets can be exchanged through various hardware connections
13 depending on the device, such as:
14   - USB with the CDC Phonet interface,
15   - infrared,
16   - Bluetooth,
17   - an RS232 serial port (with a dedicated "FBUS" line discipline),
18   - the SSI bus with some TI OMAP processors.
19
20
21 Packets format
22 --------------
23
24 Phonet packet have a common header as follow:
25
26   struct phonethdr {
27     uint8_t  pn_media;  /* Media type (link-layer identifier) */
28     uint8_t  pn_rdev;   /* Receiver device ID */
29     uint8_t  pn_sdev;   /* Sender device ID */
30     uint8_t  pn_res;    /* Resource ID or function */
31     uint16_t pn_length; /* Big-endian message byte length (minus 6) */
32     uint8_t  pn_robj;   /* Receiver object ID */
33     uint8_t  pn_sobj;   /* Sender object ID */
34   };
35
36 The device ID is split: the 6 higher order bits consitutes the device
37 address, while the 2 lower order bits are used for multiplexing, as are
38 the 8-bits object identifiers. As such, Phonet can be considered as a
39 network layer with 6 bits of address space and 10 bits for transport
40 protocol (much like port numbers in IP world).
41
42 The modem always has address number zero. Each other device has a its
43 own 6-bits address.
44
45
46 Link layer
47 ----------
48
49 Phonet links are always point-to-point links. The link layer header
50 consists of a single Phonet media type byte. It uniquely identifies the
51 link through which the packet is transmitted, from the modem's
52 perspective.
53
54 Linux Phonet network interfaces use a dedicated link layer type
55 (ETH_P_PHONET) which is out of the Ethernet type range. They can only
56 send and receive Phonet packets.
57
58 Note that Phonet interfaces are not allowed to re-order packets, so
59 only the (default) Linux FIFO qdisc should be used with them.
60
61
62 Network layer
63 -------------
64
65 The Phonet socket address family maps the Phonet packet header:
66
67   struct sockaddr_pn {
68     sa_family_t spn_family;    /* AF_PHONET */
69     uint8_t     spn_obj;       /* Object ID */
70     uint8_t     spn_dev;       /* Device ID */
71     uint8_t     spn_resource;  /* Resource or function */
72     uint8_t     spn_zero[...]; /* Padding */
73   };
74
75 The resource field is only used when sending and receiving;
76 It is ignored by bind() and getsockname().
77
78
79 Low-level datagram protocol
80 ---------------------------
81
82 Applications can send Phonet messages using the Phonet datagram socket
83 protocol from the PF_PHONET family. Each socket is bound to one of the
84 2^10 object IDs available, and can send and receive packets with any
85 other peer.
86
87   struct sockaddr_pn addr = { .spn_family = AF_PHONET, };
88   ssize_t len;
89   socklen_t addrlen = sizeof(addr);
90   int fd;
91
92   fd = socket(PF_PHONET, SOCK_DGRAM, 0);
93   bind(fd, (struct sockaddr *)&addr, sizeof(addr));
94   /* ... */
95
96   sendto(fd, msg, msglen, 0, (struct sockaddr *)&addr, sizeof(addr));
97   len = recvfrom(fd, buf, sizeof(buf), 0,
98                  (struct sockaddr *)&addr, &addrlen);
99
100 This protocol follows the SOCK_DGRAM connection-less semantics.
101 However, connect() and getpeername() are not supported, as they did
102 not seem useful with Phonet usages (could be added easily).
103
104
105 Authors
106 -------
107
108 Linux Phonet was initially written by Sakari Ailus.
109 Other contributors include Mikä Liljeberg, Andras Domokos,
110 Carlos Chinea and Rémi Denis-Courmont.
111 Copyright (C) 2008 Nokia Corporation.